On Thu, Aug 14, 2008 at 2:28 PM, Joe Fernandez <[EMAIL PROTECTED]> wrote: > > If for example you start() a connection with 'failover' and you set > maxReconnectAttempts to 2, start() throws an exception after 2 reconnect > attempts. That's fine. However, if you then go back and issue the start() > again on the same connection, the 2 reconnect attempts will no longer be > attempted. The reconnect functionality for that connection is now fubar. >
I see you want the method to error out on timeout but you want the next method call to attempt to re-establish the connection. I'll have to thing about how to implement this. > I tried calling connection.cleanup() prior to the second start(), because > according to this method's comments, calling cleanup() should bring the > connection back to a state "as if the connection was just created". This > does not help. > That's more for the internal jms connection state.. it does not reset the transport which is what is needed. > Should a JIRA be opened for this? What would be cool is a patch implementing your requested change. > > Joe > http://www.ttmsolutions.com > > > > Hiram Chirino wrote: >> >> Not sure I understand? So on failure you want to auto reconnect but >> you don't want to block until the reconnection happens? Not this is >> possible when connecting to a remote broker. >> >> Perhaps your best bet is to use an embedded broker so that way you >> never have broker failure. All your operations never block and you >> just configure the embedded broker to network with the remote brokers >> so that messages get forwarded when they come back online. >> >> >> On Mon, Aug 11, 2008 at 11:40 PM, Wing <[EMAIL PROTECTED]> wrote: >>> >>> I am using spring for activemq connection, I would like to >>> reconnect/recover >>> the broker connection if the broker is down. I know we can use failover: >>> in >>> the url, but it will cause the tomcat to be held until it can connect to >>> the >>> broker. >>> If I set the retry limit in the url, it will not auto reconnect anymore >>> afterwards. >>> >>> Any other way to do recovery except configurating the failover url? >>> >>> I am using org.apache.activemq.pool.PooledConnectionFactory >>> >>> Thanks. >>> -- >>> View this message in context: >>> http://www.nabble.com/How-to-recover-active-connection-if-it-is-down-when-using-spring--tp18937550p18937550.html >>> Sent from the ActiveMQ - User mailing list archive at Nabble.com. >>> >>> >> >> >> >> -- >> Regards, >> Hiram >> >> Blog: http://hiramchirino.com >> >> Open Source SOA >> http://open.iona.com >> >> > > -- > View this message in context: > http://www.nabble.com/How-to-recover-active-connection-if-it-is-down-when-using-spring--tp18937550p18987040.html > Sent from the ActiveMQ - User mailing list archive at Nabble.com. > > -- Regards, Hiram Blog: http://hiramchirino.com Open Source SOA http://open.iona.com
