Hi Brandon,
Thank you for your updating. I didn't use vlan, and I've added the new ip subnet to a new pod of my cs. After added some vms, there is no vms assign new ips. I need to configure vrouter manually? Thank you. Steven On 12/12/2013 12:27 PM, Brandon Arms wrote: Here is the citrix answer:Extending your IP range If you want to extend the range. You can add another IP range by clicking on Add IP Range and then specify the same network & VLAN settings, except specify the a new IP range in the same subnet. Do not overlap the existing public IP range. The issue I found is my current public ip range is limited by my current subnet mask. For example, if your public range is something like this: Gateway: 1.1.1.1 Netmask: 255.255.255.224 Vlan: 10 Startip: 1.1.1.2 endIP: 1.1.1.30 I cannot extend my range as I only have 32 addresses available per my subnet mask, so the citrix solution is not an option. I assume the citrix solution is valid if you have something defined like this: Gateway: 1.1.1.1 Netmask: 255.255.255.0 Vlan: 10 Startip: 1.1.1.2 endIP: 1.1.1.30 now you have 256 possible ip addresses per your mask, but are only allowing a subset of those to be assigned. I think in my case, I would have to find where this information is kept in the DB, and modify my subnet mask first, and then proceed with extending via the citrix solution. The other option is to just add another vlan/subnet for the system account to use versus trying to extend your current one. Brandon Arms DSS -----Original Message----- From: Steven Liang [mailto:stevenli...@yesup.com] Sent: Thursday, December 12, 2013 11:17 AM To: users@cloudstack.apache.org Subject: how to add new public subnets to my cs(basic networking mode) Hi everyone, Could you please tell me how to add new public subnets to my cs? Because my existing ips will exhausted. Thank you. Regards, Steven --
Steven Liang Linux System Admin Phone: 1.416.499.8009 ext. 2865 Cell Phone: 1.647.718.5292 Email: stevenli...@yesup.com www.yesup.com | account.yesup.com ![]() |
- how to add new public subnets to my cs(basic networking mode) Steven Liang
- RE: how to add new public subnets to my cs(basic network... Brandon Arms
- Re: how to add new public subnets to my cs(basic net... Steven Liang
- Re: how to add new public subnets to my cs(basic... Steven Liang