FYI: There are three different interfaces configured/enabled/functioning on this host:
1 active-passive bonded interface [172.16.0.1/24] consisting of two slaves (p1p3 & p1p4). 2 physical interfaces (p1p1 [172.16.1.3/25] & p1p2 [172.16.1.131/25]). During the /usr/bin/cloudstack-setup process, *when prompted "Please choose which network used to create VM:[bond0]*, it doesn't seem to make any difference what answer I provide - bond0, p1p1, 172.16.1.3, p1p2, or 172.16.1.131. The CloudStack agent fails to start. Ideas? Suggestions? TIA, Eric P. On Wed, Jun 3, 2020 at 2:40 PM Practical XenServer < practicalxenser...@gmail.com> wrote: > Thanks, Fariborz. > > But you're pointing me to the same page that I referenced in my original > message i.e., > > /en/latest/installguide/hypervisor/kvm.html = /en/4.6/hypervisor/kvm.html > > Do you have any *new* information to share? > > TIA, > Eric P. > > On Wed, Jun 3, 2020 at 2:27 PM Fariborz Navidan <mdvlinqu...@gmail.com> > wrote: > >> Hello, >> >> This happens when bridges are not configured on the host and there is no >> private ip assigned to your nic. Please check your bridge config as >> mentions in installation documentation here: >> >> http://docs.cloudstack.apache.org/projects/cloudstack-installation/en/4.6/hypervisor/kvm.html >> >> On Thu, Jun 4, 2020 at 1:51 AM Practical XenServer < >> practicalxenser...@gmail.com> wrote: >> >> > Hello! >> > >> > I've been following the installation instructions for installing the >> > CloudStack agent on a CentOS-7 KVM host >> > < >> > >> http://docs.cloudstack.apache.org/en/latest/installguide/hypervisor/kvm.html#install-and-configure-the-agent >> > >: >> > But I can't get the cloudstack-agent to start. e.g., From the end of >> > /var/log/cloudstack/agent/agent.log: >> > >> > > Jun 3 17:06:48 vmh-1 systemd: cloudstack-agent.service: main process >> > exited, code=exited, status=66/n/a >> > > Jun 3 17:06:48 vmh-1 systemd: Unit cloudstack-agent.service entered >> > failed state. >> > > Jun 3 17:06:48 vmh-1 systemd: cloudstack-agent.service failed. >> > >> > I've collected all of the evidence that seems relevant >> > <https://pastebin.com/eRvTEQX0> (e.g., interface configuration & >> status; >> > the configuration & status of libvirtd; etc) and put it in Pastebin. >> > >> > Would somebody please help me fix my installation of cloudstack-agent? >> > >> > TIA, >> > Eric Pretorious >> > Portland, Oregon >> > >> >