Hello Lori, so looks like something is working now :)
LISP to LISP is working : Gateway#ping 153.16.54.163 source GigabitEthernet0/1 Type escape sequence to abort. Sending 5, 100-byte ICMP Echos to 153.16.54.163, timeout is 2 seconds: Packet sent with a source address of 153.16.53.161 !!!!! Success rate is 100 percent (5/5), round-trip min/avg/max = 156/160/164 ms but LISP to NON-LISP is not working ... as PETR / PITR i'm using the same ones as i use for regular lisp on my cisco router... Ideas? Thanks, Andrea 2014-12-17 14:45 GMT+01:00 Andrea Florio <[email protected]>: > > Hello Lori, > > thanks again for your help > > 2014-12-17 13:34 GMT+01:00 Lori Jakab <[email protected]>: >> >> How do you test? >> >> > I am doing reach-ability tests. From both, a lisp enabled router, and a > non lisp router. i cannot reach the EID 153.16.53.163/32 in both cases. > But i have no problems with the was address (90.177.68.57) > > >> Please remove the IPv6 PITRs from the list, since you don't seem to have >> IPv6 connectivity and there are some error messages because of that >> cluttering the logs, which will make it more difficult for you to spot >> real problems. >> > > done thanks > > >> There is nothing wrong here, the above behavior is expected. The IP >> address that you see as your RLOC is the RLOC of the RTR that is being >> used for NAT traversal. See more details in the draft that Alberto >> referenced. >> >> > my apologies if i didn't go trough the whole document, but i don't have > reach-ability, and this is why i believe something is not behaving as > supposed to (doesn't have to be lispmob itself though, of course). > The other strange thing i observe is that a traceroute, is becoming > un-responsive at every attempt few hops shorter. > > > now, if i was on a router, i would configure lisp without nat aware > feature. I would then create a locator set by using my public ip address (a > loopback with my public ip /32 my be required) . > but this is not an option with lispmob as it seems that i can only specify > and interface in my database mapping. > > Andrea > > -- > ------------------------------------------ > Andrea Florio > AT&T Brno - Senior Network Architect > CISCO CCNA Wireless and Security, CCNP Certified > openSUSE Official Member (anubisg1) > Email: [email protected] > Email: [email protected] > Cell: +39-328-7365667 > Cell: +420-778-033288 > Website: http://journey4ccie.com/ > ------------------------------------------ > -- ------------------------------------------ Andrea Florio AT&T Brno - Senior Network Architect CISCO CCNA Wireless and Security, CCNP Certified openSUSE Official Member (anubisg1) Email: [email protected] Email: [email protected] Cell: +39-328-7365667 Cell: +420-778-033288 Website: http://journey4ccie.com/ ------------------------------------------
