I opened an issue on GitHub: https://github.com/genodelabs/genode/issues/2973
On Fri, Aug 31, 2018 at 1:33 PM Nobody III <hungryninja...@gmail.com> wrote: > Okay, it looks like I missed that earlier. Is there an issue open on > GitHub? > > On Fri, Aug 31, 2018 at 2:05 AM Josef Söntgen < > josef.soent...@genode-labs.com> wrote: > >> Hello Ben, >> >> * Nobody III <hungryninja...@gmail.com> [2018-08-30 23:38:47 -0600]: >> >> > I updated to the 18.08 Genode release, built a Sculpt image, then >> booted it >> > on my Dell Latitude 6430u laptop. I discovered that the WiFi driver, >> which >> > worked in 18.05 (Sculpt TC) no longer works properly. In particular, the >> > WiFi driver detects the access points and can connect to them, but >> doesn't >> > get an IP address. I tried multiple access points, both my wireless >> router >> > and my phone. With my phone, I used a clean lowercase alphabetic SSID >> > ("bensphone"), to avoid any issues with problematic characters. I am >> using >> > an Intel Ultimate-N 6300 wireless card.. Wired networking still works. >> >> as noted in the release notes, support for 6000er cards has regressed with >> the new driver. The cause is still unknown and we are working on a fix. >> >> (It looks like some kind of race or timing issue as most of the time the >> packets submitted to the firmware are not acknowledged but sometimes it >> works just fine and the behaviour is influenced by debug messages.) >> >> Regards, >> -- >> Josef Söntgen >> Genode Labs >> >> http://www.genode-labs.com/ · http://genode.org/ >> _______________________________________________ >> Genode users mailing list >> users@lists.genode.org >> https://lists.genode.org/listinfo/users > >
_______________________________________________ Genode users mailing list users@lists.genode.org https://lists.genode.org/listinfo/users