Hi Klaus You are referring to line 17 right ? That part of traffic is from openser to the pstn gw ..and both of those are UDP..should it be transport=tls there or transport=udp? Thanks
With Regards Ali Jawad System Administrator Splendor Telecom (www.splendor.net) Beirut, Lebanon Phone: +961 1 373725 Fax: +961 1 375554 -----Original Message----- From: Klaus Darilion [mailto:[EMAIL PROTECTED] Sent: 2008-08-29 14:34 To: Ali Jawad Cc: users@lists.kamailio.org Subject: Re: [Kamailio-Users] FW: Call Hangup from Caller-End not working with TLS 1. INVITE: Contact: <sip:[EMAIL PROTECTED]:2949;transport=UDP;rinstance=D98C1DD404B2008F 980980E97E42F8EC;nat=yes>. As you see the caller announces UDP as contact. Either a bug in the caller client or do you rewrite the contact in openser? Further it is strange that the caller sends frmo 127.0.0.1 (Via header, SDP) but announces a different IP in contact. regards klaus Ali Jawad schrieb: > Dear All > > Please find below the call setup from my softphone to my cell phone, The > setup is as follows: > > LAN -> Office Gateway <--TLS--->Openser<--UDP-->PSTN GW > > I got the trace below by applying > > ngrep -W byline -T username -q -d eth0 > > http://pastebin.com/m2a78a27f > > I did the same trace for a udp call and it seemed identical to me, as > you can see in the lower part of the trace that a BYE packet is being > sent to the softphone however the transport is being indicated as UDP > not TLS..is this normal ? > Any clues apart from that ? > > Thanks > > -----Original Message----- > From: Klaus Darilion [mailto:[EMAIL PROTECTED] > Sent: 2008-08-28 18:13 > To: Ali Jawad > Cc: users@lists.kamailio.org > Subject: Re: [Kamailio-Users] FW: Call Hangup from Caller-End not > working with TLS > > Hi! > > Send us an ngrep dump: ngrep -P "" -W byline port 5060 > > Although this will show us only the UDP part (as TLS is encrypted) but > may still show as the problem. > > Which SIP client do you use? > > regards > klaus > > Ali Jawad schrieb: >> Hi All >> >> I am using using openser 1.3..if I make a call between two softphones > on >> the same lan or a a pstn call to my mobile phone..and the >> called/receiver party does hang-up the call. It works fine in UDP mode > >> and the call get's hang-up. However in TLS mode this does not work. >> Anything I might have missed here? Since both udp and tls use the same > >> routes, and voice is fine and no one way audio ..etc. >> >> I notice this http://pastebin.com/m38c979f6 on rtp proxy. However in > the >> logs of openser I can't see any errors. >> >> However on the wire shark I can see icmp destination > unreachable...port >> unreachable. >> >> I would have said it is a NAT issue. However it works for simple UDP. >> >> >> >> However I did notice the following in the logs >> >> >> >> Aug 28 13:41:01 [8565] DBG:tm:set_timer: relative timeout is 4000000 >> >> Aug 28 13:41:01 [8565] DBG:tm:insert_timer_unsafe: [7]: 0xb6137794 >> (45900000) >> >> Aug 28 13:41:01 [8565] DBG:tm:retransmission_handler: >> retransmission_handler : done >> >> Aug 28 13:41:02 [8564] DBG:core:parse_msg: SIP Request: >> >> Aug 28 13:41:02 [8564] DBG:core:parse_msg: method: <BYE> >> >> Aug 28 13:41:02 [8564] DBG:core:parse_msg: uri: >> > <sip:[EMAIL PROTECTED]:3218;transport=UDP;rinstance=D98C1DD404B200 > 8F980980E97E42F8EC;nat=yes> >> Aug 28 13:41:02 [8564] DBG:core:parse_msg: version: <SIP/2.0> >> >> Aug 28 13:41:02 [8564] DBG:core:parse_headers: flags=2 >> >> Aug 28 13:41:02 [8564] DBG:core:parse_via_param: found param type 232, > >> <branch> = >> >> >> >> Shouldn't the transport=TLS ? >> >> >> >> >> >> Regards >> >> >> > ------------------------------------------------------------------------ >> _______________________________________________ >> Users mailing list >> Users@lists.kamailio.org >> http://lists.kamailio.org/cgi-bin/mailman/listinfo/users > -- This message has been scanned for viruses and dangerous content by MailScanner, and is believed to be clean. _______________________________________________ Users mailing list Users@lists.kamailio.org http://lists.kamailio.org/cgi-bin/mailman/listinfo/users