On 2014-04-14 10:52, Marco Fanti wrote:
You should give more information about your setup.
What openflow controller are you using?
Floodlight (from http://www.projectfloodlight.org/) in default
configuration (tried also learning switch config).
And the controller is controlling only the physical switches or also the
OpenVSwitches? (I think this last option is not possible without a lot
of work)
Physical switches are IBM EN4093R (10Gb) and connected with openflow to
the same floodlight controller. openvswitch is of 1.4.2 in Debian 7.4.
# ovs-vsctl show
8505aff4-42e3-48c2-9173-fa0fbe5caeb3
Bridge "br0"
Controller "tcp:192.168.42.68:6633"
is_connected: true
Port "eth0"
Interface "eth0"
br0 have IP, eth0 have no IP.
With floodlight in forwarding mode I have connectivity between
hypervisor nodes (with IP of br0) and to storage nodes (for iSCSI), but
VMs on different nodes doesn't see each other.
Regards, Rolandas
2014-04-13 21:36 GMT+02:00 Rolandas Naujikas
<rolandas.nauji...@mif.vu.lt <mailto:rolandas.nauji...@mif.vu.lt>>:
Hi,
I'm trying to use openflow controller + openvswitch + KVM + hardware
switch with openflow support.
Could provide some advice, because I cannot get it running by using
opennebula default config + kvm + openvswitch (ping works with VMs
in the same node and fails to VMs in another nodes).
Regards, Rolandas
_________________________________________________
Users mailing list
Users@lists.opennebula.org <mailto:Users@lists.opennebula.org>
http://lists.opennebula.org/__listinfo.cgi/users-opennebula.__org
<http://lists.opennebula.org/listinfo.cgi/users-opennebula.org>
_______________________________________________
Users mailing list
Users@lists.opennebula.org
http://lists.opennebula.org/listinfo.cgi/users-opennebula.org