Try adding your extra headers to the "cusotm_headers" parameter: http://www.opensips.org/html/docs/modules/devel/b2b_logic.html#id250014
Regards, Ovidiu Sas On Sat, Jul 2, 2011 at 5:46 AM, Jayesh Nambiar <[email protected]> wrote: > Hi All, > I have a following situtation: > Sip-Endpoint --> Opensips B2B (with REFER scenario) --> Opensips Proxy(Using > Proxy Authorize for Authentication) --> PSTN Gateway > I need the "B2B Opensips" in between so that it can handle the REFER > requests properly. The problem is that the "Proxy Opensips" responds back as > 407 with Proxy-Authenticate header along with the realm and nonce value; but > the "B2B Opensips" would only send the 407 response to the Endpoint without > any Proxy-Authenticate header. Thus the call fails. I cannot authorize the > Sip-Endpoint on the "B2B Opensips" because of the limitations of my > architecture. > What I need is, the 407 response gets back to the Sip-Endpoint transparently > and the response to the same also reaches the "Proxy Opensips" properly, so > that the proxy authorization becomes successful and the call can go through > properly. > Is there something that can be done on the b2b_response route? Any pointers > or directions in achieving this will be very helpful !! > Thanks in advance. > --- Jayesh > > _______________________________________________ > Users mailing list > [email protected] > http://lists.opensips.org/cgi-bin/mailman/listinfo/users > > _______________________________________________ Users mailing list [email protected] http://lists.opensips.org/cgi-bin/mailman/listinfo/users
