Tarik, This problem is common when you were previously compiling and then switched to the debs since the prefix is different. Make sure you remove the manually compiled binaries/modules and your module path inside your opensips.cfg points to the new module directory.
You can check which version of opensips binary you are running by using the command "which opensips" . The paths are broken down below: Paths (for deb/apt installs): binaries: /usr/sbin modules: /usr/lib/opensips/modules Paths (default source install with no prefix option): binaries: /usr/local/sbin modules: /usr/local/lib/opensips/modules Thanks in advance, --Rudy Dynamic Packet Toll-Free: 888.929.VOIP ( 8647 ) On Mon, Feb 27, 2012 at 5:26 PM, Bogdan-Andrei Iancu <bog...@opensips.org> wrote: > Hi Tarik, > > actually, what you experienced was a partial re-installation - the opensips > core (the opensips binary) was still the old one (from non tls version), > while the modules (dynamic libs) where from the new installation (with TLS > support). > > It may be a configuration error where the config file was point to modules > in an directory belonging to the old installation. You just have to be > careful with the used directories, not need to un-install. > > Regards, > Bogdan > > On 02/26/2012 08:27 AM, Tarik Tankovic wrote: >> >> Solved! >> >> First, OpenSIPS was totally manually uninstalled and after that I >> installed OpenSIPS version with TLS support. >> >> Tarik >> >> On 2/24/12, Tarik Tankovic<ttanko...@gmail.com> wrote: >>> >>> Hi, >>> >>> first I compiled and installed OpenSIPS 1.6.0-notls version and it >>> worked just fine. >>> >>> After that I downloaded OpenSIPS 1.6.0-tls -tar.gz file and tried to >>> include TLS support so I changed Makefile in the way I uncommented >>> TLS=1 line and entered commands make prefix=/all and make >>> prefix=/install. >>> >>> Now I tried to check configuration file opensips.cfg using opensips -c >>> but I got following error: >>> >>> ERROR:core:version_control: module version mismatch for signaling; >>> core: opensips 1.6.0-notls (i386/linux); module: opensips 1.6.0-tls >>> (i386/linux) >>> >>> and of course I am not able to start opensips. >>> >>> How can I upgrade version of signalin module in the core to the >>> 1.6.0-tls version? >>> >>> Thanks, >>> >>> Tarik >>> >> _______________________________________________ >> Users mailing list >> Users@lists.opensips.org >> http://lists.opensips.org/cgi-bin/mailman/listinfo/users >> > > > -- > Bogdan-Andrei Iancu > OpenSIPS Founder and Developer > http://www.opensips-solutions.com > > > _______________________________________________ > Users mailing list > Users@lists.opensips.org > http://lists.opensips.org/cgi-bin/mailman/listinfo/users _______________________________________________ Users mailing list Users@lists.opensips.org http://lists.opensips.org/cgi-bin/mailman/listinfo/users