Hi Bodgan,

I have sent you SIP capture in private as the server was on public IP.

Regards,
Qasim


On Fri, May 17, 2013 at 3:50 PM, Bogdan-Andrei Iancu <bog...@opensips.org>wrote:

> **
> Hello Qasim,
>
> So you have multiple interfaces in OpenSIPS - are all of them the same
> protocol ?
>
> Please try to post a SIP capture of the full call, to see how the RR part
> is done.
>
> Regards,
>
> Bogdan-Andrei Iancu
> OpenSIPS Founder and Developerhttp://www.opensips-solutions.com
>
>
> On 05/16/2013 01:07 PM, qasimak...@gmail.com wrote:
>
> On further investigation i see that i only face this issue when both
> caller and callee are on the same network. If both are on separate network
> it works fine.
>
> Regards,
> Qasim
>
>
> On Thu, May 16, 2013 at 3:05 PM, qasimak...@gmail.com <
> qasimak...@gmail.com> wrote:
>
>>  yes.
>>
>>  Regards,
>> Qasim
>>
>>
>> On Thu, May 16, 2013 at 2:50 PM, Bogdan-Andrei Iancu <bog...@opensips.org
>> > wrote:
>>
>>>  And do you have UDP 202.152.203.195 port 6000 as listener defined in
>>> OpenSIPS ??
>>>
>>> Regards,
>>>
>>> Bogdan-Andrei Iancu
>>> OpenSIPS Founder and Developerhttp://www.opensips-solutions.com
>>>
>>>
>>>   On 05/16/2013 12:32 PM, qasimak...@gmail.com wrote:
>>>
>>>  Hi Bodgan,
>>>
>>>  Yes i see the following route header in my packet.
>>>
>>> Route:
>>> <sip:622190004002@202.152.203.195:6000;lr;ftag=3b710c25;did=e55.a77ff685>
>>>
>>>
>>>  And yes i am routing it through loose_route.
>>>
>>>  Regards,
>>> Qasim
>>>
>>>
>>> On Wed, May 15, 2013 at 10:40 PM, Bogdan-Andrei Iancu <
>>> bog...@opensips.org> wrote:
>>>
>>>>  Hello Qasim,
>>>>
>>>> The ACK should be routed via loose_route() based on the "Route" headers
>>>> from it. Could you check if the Route hdrs (from the ACK) are correctly
>>>> reflecting your opensips interfaces ?
>>>>
>>>> Best regards,
>>>>
>>>> Bogdan-Andrei Iancu
>>>> OpenSIPS Founder and Developerhttp://www.opensips-solutions.com
>>>>
>>>>
>>>> On 05/14/2013 07:55 AM, qasimak...@gmail.com wrote:
>>>>
>>>>   Hi,
>>>>
>>>>  I am using OpenSIPs in Public<->Private bridging mode and have enabled
>>>> mhomed=1. But the problem is that when we have a call in which both parties
>>>> are on Public interface the INVITE gets relayed properly but and ACK of
>>>> that invite gives the following error.
>>>>
>>>> ERROR:core:get_out_socket: no socket found
>>>> ERROR:core:forward_request: cannot forward to af 2, proto 1 no
>>>> correspondinglistening socket
>>>>
>>>>  Regards,
>>>> Qasim
>>>>
>>>>
>>>> _______________________________________________
>>>> Users mailing 
>>>> listUsers@lists.opensips.orghttp://lists.opensips.org/cgi-bin/mailman/listinfo/users
>>>>
>>>>
>>>
>>
>
_______________________________________________
Users mailing list
Users@lists.opensips.org
http://lists.opensips.org/cgi-bin/mailman/listinfo/users

Reply via email to