Hi Artiom,
So you initially had only the trace_on set in the proto_tls module,
generating some HEP packages which were not understood by HOMER, right ?
And after setting the trace_on in the proto_tcp module, the issue went
away? but do you get HEP packages about about the TCP and TLS events in
OpenSIPS - I'm asking as I have to say this part was not tested by some
time :-/
Regards,
Bogdan-Andrei Iancu
OpenSIPS Founder and Developer
https://www.opensips-solutions.com
OpenSIPS Summit 27-30 Sept 2022, Athens
https://www.opensips.org/events/Summit-2022Athens/
On 8/10/22 5:44 AM, Artiom Druz wrote:
Hi Bogdan.
I use trace_on parameter of proto_tls module and subroute for sending
messages to Homer.
I enabled trace_on parameter for proto_tcp module and now it works
correct. I'm not sure if this is the only fix I made because it may
have been a misconfiguration in the script logic.
вт, 9 авг. 2022 г., 13:42 Bogdan-Andrei Iancu <[email protected]
<mailto:[email protected]>>:
Hi Artiom,
Do you use any proto TCP or TLS specific tracing (like [1]), or
only pure SIP TLS tracing ?
[1]
https://opensips.org/html/docs/modules/3.2.x/proto_tls.html#param_trace_on
<https://opensips.org/html/docs/modules/3.2.x/proto_tls.html#param_trace_on>
Regards,
Bogdan-Andrei Iancu
OpenSIPS Founder and Developer
https://www.opensips-solutions.com <https://www.opensips-solutions.com>
OpenSIPS Summit 27-30 Sept 2022, Athens
https://www.opensips.org/events/Summit-2022Athens/
<https://www.opensips.org/events/Summit-2022Athens/>
On 7/25/22 11:20 AM, Artiom Druz wrote:
Hello Everyone.
I have a problem with monitoring SIPS/TLS based on tls_wolfssl
module via proto_hep (target monitoring service is Homer 7).
My opensips config works ok with SIP/UDP, but when I make a call
via TLS (OpenSIPS convert TLS from VoIP provider to internal
SIP/UDP software PBX) in dump file on Homer 7 side I see that all
packets in HEP3 payload has this info:
HEP3 Protocol
HEP Version: HEP3
HEP Packet Size (Bytes): 152
IP family: IPv4
Ingested Transport Protocol: IPv4
Source port: 0
Destination port: 0
Unix Timestamp: 1658731857
Timestamp µs: 106136
Application Protocol: Unknown Application Protocol
Capture Node ID: 1301
Source IPv4 address: 127.0.0.2
Destination IPv4 address: 127.0.0.2
Encapsulated Payload: TLS:CLOSED:SUCCESS:Read error
Correlation ID: 350784072629638188
Only unix timestamp and capture node id is correct.
As you can see in encapsulated payload I have an error with read.
What can be wrong?
OpenSIPS 3.2.5 (git revision 7e284ab03) compiled from source.
_______________________________________________
Users mailing list
[email protected] <mailto:[email protected]>
http://lists.opensips.org/cgi-bin/mailman/listinfo/users
<http://lists.opensips.org/cgi-bin/mailman/listinfo/users>
_______________________________________________
Users mailing list
[email protected]
http://lists.opensips.org/cgi-bin/mailman/listinfo/users
