Hi, I have a configuration like below and VPN connection successfully established but client side get "1.1.1.127" as tunnel IP. Can we change this tunnel IP? I can not find any clue about why StrongSwan assign "1.1.1.127" as tunnel IP to clients?
Thanks. *StrongSwan Config (Left)* conn vpn-test left=%defaultroute leftsubnet=172.30.1.1/25 leftauth=psk leftfirewall=no right=%any rightsubnet=0.0.0.0/0 rightsourceip=10.254.0.0/24 auto=add keyexchange=ikev1 rightauth=psk rightauth2=xauth type=tunnel mobike=yes rightid=%any *Client VPN Status: (Aruba Instant AP - Right)* current using tunnel :primary tunnel current tunnel using time :1 hour 43 minutes 31 seconds ipsec is preempt status :disable ipsec is fast failover status :disable ipsec hold on period :0s ipsec tunnel monitor frequency (seconds/packet) :5 ipsec tunnel monitor timeout by lost packet cnt :6 ipsec primary tunnel crypto type :PSK ipsec primary tunnel peer address :52.55.49.104 ipsec primary tunnel peer tunnel ip :1.1.1.127 ipsec primary tunnel ap tunnel ip :10.254.0.1 ipsec primary tunnel using interface :tun0 ipsec primary tunnel using MTU :1230 ipsec primary tunnel current sm status :Up ipsec primary tunnel tunnel status :Up ipsec primary tunnel tunnel retry times :6 ipsec primary tunnel tunnel uptime :1 hour 43 minutes 31 seconds ipsec backup tunnel crypto type :PSK ipsec backup tunnel peer address :N/A ipsec backup tunnel peer tunnel ip :N/A ipsec backup tunnel ap tunnel ip :N/A ipsec backup tunnel using interface :N/A ipsec backup tunnel using MTU :N/A ipsec backup tunnel current sm status :Init ipsec backup tunnel tunnel status :Down ipsec backup tunnel tunnel retry times :0 ipsec backup tunnel tunnel