Hi Gianluca,
yes, you are right. Now second and third host can be directly added
from UI. Before adding the second and third host please make sure that
the following steps are done for hyperconverged setup.
1) On Hosted engine vm run the command 'engine-config -s
AllowClusterWithVirtGlusterEnabled=true'
2) Restart ovirt-engine by running the command 'service ovirt-engine
restart'
3) /Edit Cluster/>/Default/>/Enable the gluster service/.
4) Create separate storage domains for each gluster volume. You can see
that hosted_storage gets imported into the UI automatically when one
storage domain is created in the UI.
5) Add second and third host from UI.
Hope this helps
Thanks
kasturi
On 11/16/2016 06:43 AM, Gianluca Cecchi wrote:
Hello,
I'm testing hyperconverged setup with gluster and oVirt 4.0.5 and
three hosts and self hosted engine.
I'm at the point where first host is ok and engine up and I have to
deploy second and third host.
In the past the command to give on them was
root@host2 # hosted-engine --deploy
and at the end of it
root@host3 # hosted-engine --deploy
But I also seem to remember that perhaps this has been superseded and
possible to direct deploy now host2 and host3 from web admin gui with
Hosts --> New
Is this true in general? And in particular in my case?
Thanks in advance,
Gianluca
_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users
_______________________________________________
Users mailing list
Users@ovirt.org
http://lists.ovirt.org/mailman/listinfo/users