Is there a particular "port" and/or "protocol (TCP/UDP) that must be
opened on any firewalls that might be on the network for the plugin to
work?
On Jul 8, 2005, at 6:25 PM, Matt Kettler wrote:
Dr Robert Young wrote:
I have been looking at the incorporation or SURBL into the SA 3.0.4
release (I will say up front I am very early on the learning curve
for SA).
I have read that the SURBL support is built in by default in SA 304,
and
I can see where the plugin is loaded in init.pre.
However, is there any other config parameter, etc that is needed to
actually "initiate" their use? Is it active "by default" so long as
one
is not running in -L (local) mode?
Yes, provided two things:
1) (as suggested by Martin) you need a very recent version of Net::DNS
2) init.pre needs to be in your /etc/mail/spamassassin/ directory. If
you
installed from the official source tarball it should be there, but some
distribution packages screwed up and left this file out. init.pre is
important
in this case, as it contains the loadplugin command that activates the
URIBL plugin.
________________________________________________________
Dr. Robert Young
ALI Database Consultants
1151 Williams Dr
Aiken SC 29803
USA
WWW: http://www.aliconsultants.com
Tele: 1-803-648-5931
Toll free in US: 1-866-257-8970 Fax:1-803-641-0345
Email: [EMAIL PROTECTED]
"Source of Rdb Controller, software for database analysis &
performance tuning"
