Nate, I upgraded to UHD 003.009.007, and it worked in CentOS7.2. I can now probe the daughtercard and get a return.
Thank you so much! Mark From: Nate Temple <nate.tem...@ettus.com> Date: Tuesday, October 17, 2017 at 5:19 PM To: Mark Koenig <mark.koe...@iubelttechnologies.com> Cc: "usrp-users@lists.ettus.com" <usrp-users@lists.ettus.com> Subject: Re: [USRP-users] UBX-160 with X310 communication issue Hi Mark, The UBX v2 is not supported using UHD 3.9.3. Support for the UBX v2 was added with UHD 3.9.5 and UHD 3.10.2.0. Can you please try updating to the newest UHD, such as 3.9.7 or 3.10.2.0 and try probing USRP/DBs again? Regards, Nate Temple On Tue, Oct 17, 2017 at 1:01 PM, Mark Koenig via USRP-users <usrp-users@lists.ettus.com<mailto:usrp-users@lists.ettus.com>> wrote: Hello, I am looking for some help with respect to the UBX-160. I have two version 2 daughtercards which were purchased a couple of months ago. I am running on CentOS 7.2 and CentOS 6.5 with GNU radio version 3.7.4 and UHD version 003.009.003. I can ping the USRP and also return information on the uhd_find_devices command, however, when I run the uhd_usrp_probe command I do not get a return for the daughtercards. The example output is below. Any help would be EXTREMELY appreciated. Thank you Mark linux; GNU C++ version 4.4.7 20120313 (Red Hat 4.4.7-16); Boost_105300; UHD_003.009.004-0-g2b5a88bb -- X300 initialization sequence... -- Determining maximum frame size... 1472 bytes. -- Setup basic communication... -- Loading values from EEPROM... -- Setup RF frontend clocking... -- Radio 1x clock:200 -- Detecting internal GPSDO.... Found an internal GPSDO -- Initialize Radio0 control... -- Performing register loopback test... pass -- Initialize Radio1 control... -- Performing register loopback test... pass _____________________________________________________ / | Device: X-Series Device | _____________________________________________________ | / | | Mboard: X310 | | revision: 11 | | revision_compat: 7 | | product: 30818 | | mac-addr0: 00:80:2f:17:43:3f | | mac-addr1: 00:80:2f:17:43:40 | | gateway: 192.168.10.1 | | ip-addr0: 192.168.10.2 | | subnet0: 255.255.255.0 | | ip-addr1: 192.168.20.2 | | subnet1: 255.255.255.0 | | ip-addr2: 192.168.30.2 | | subnet2: 255.255.255.0 | | ip-addr3: 192.168.40.2 | | subnet3: 255.255.255.0 | | serial: 311FF4E | | FW Version: 4.0 | | FPGA Version: 19.0 | | | | Time sources: internal, external, gpsdo | | Clock sources: internal, external, gpsdo | | Sensors: gps_gpgga, gps_gprmc, gps_time, gps_locked, gps_servo, ref_locked | | _____________________________________________________ | | / | | | RX DSP: 0 | | | Freq range: -100.000 to 100.000 MHz | | _____________________________________________________ | | / | | | RX DSP: 1 | | | Freq range: -100.000 to 100.000 MHz | | _____________________________________________________ | | / | | | RX Dboard: A | | | ID: Unknown (0x007e) | | | Serial: 3120D56 | | | _____________________________________________________ | | | / | | | | RX Frontend: 0 | | | | Name: Unknown (0x007e) - 0 | | | | Antennas: | | | | Sensors: | | | | Freq range: 0.000 to 0.000 MHz | | | | Gain Elements: None | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz | | | | Connection Type: IQ | | | | Uses LO offset: No | | | _____________________________________________________ | | | / | | | | RX Codec: A | | | | Name: ads62p48 | | | | Gain range digital: 0.0 to 6.0 step 0.5 dB | | _____________________________________________________ | | / | | | RX Dboard: B | | | ID: Unknown (0x007e) | | | Serial: 3120D4A | | | _____________________________________________________ | | | / | | | | RX Frontend: 0 | | | | Name: Unknown (0x007e) - 0 | | | | Antennas: | | | | Sensors: | | | | Freq range: 0.000 to 0.000 MHz | | | | Gain Elements: None | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz | | | | Connection Type: IQ | | | | Uses LO offset: No | | | _____________________________________________________ | | | / | | | | RX Codec: B | | | | Name: ads62p48 | | | | Gain range digital: 0.0 to 6.0 step 0.5 dB | | _____________________________________________________ | | / | | | TX DSP: 0 | | | Freq range: -100.000 to 100.000 MHz | | _____________________________________________________ | | / | | | TX DSP: 1 | | | Freq range: -100.000 to 100.000 MHz | | _____________________________________________________ | | / | | | TX Dboard: A | | | ID: Unknown (0x007d) | | | Serial: 3120D56 | | | _____________________________________________________ | | | / | | | | TX Frontend: 0 | | | | Name: Unknown (0x007d) - 0 | | | | Antennas: | | | | Sensors: | | | | Freq range: 0.000 to 0.000 MHz | | | | Gain Elements: None | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz | | | | Connection Type: IQ | | | | Uses LO offset: No | | | _____________________________________________________ | | | / | | | | TX Codec: A | | | | Name: ad9146 | | | | Gain Elements: None | | _____________________________________________________ | | / | | | TX Dboard: B | | | ID: Unknown (0x007d) | | | Serial: 3120D4A | | | _____________________________________________________ | | | / | | | | TX Frontend: 0 | | | | Name: Unknown (0x007d) - 0 | | | | Antennas: | | | | Sensors: | | | | Freq range: 0.000 to 0.000 MHz | | | | Gain Elements: None | | | | Bandwidth range: 0.0 to 0.0 step 0.0 Hz | | | | Connection Type: IQ | | | | Uses LO offset: No | | | _____________________________________________________ | | | / | | | | TX Codec: B | | | | Name: ad9146 _______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com<mailto:USRP-users@lists.ettus.com> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
