Hi Jason, This magic poke should do the trick:
python $UHD_INSTALL_DIR/firmware/usrp3/x300/x300_debug.py --addr=<IP Addr> --poke=0x100058 --data=1 Regards, Nate Temple On Mon, Jul 23, 2018 at 9:45 AM, Nick Foster via USRP-users < usrp-users@lists.ettus.com> wrote: > I've solved this with the USB JTAG interface and an external machine. An > RPi will happily run Vivado Lab. > > AFAIK there are no plans to integrate a software reset into the X310. > > Nick > > On Mon, Jul 23, 2018 at 6:11 AM Jason Matusiak via USRP-users < > usrp-users@lists.ettus.com> wrote: > >> I know it has been questioned many times on here, but I wanted to verify >> something. It has always been said that there is no way to do a software >> reset on the X310; I am curious if that is "currently" or "ever?" >> >> I wasn't sure if there was a way to send a packet either via UHD or RFNoC >> that could trigger a reset of some kind (this assumes that you have a >> functioning X310 on the other end), and no one has had time to look into >> it? Or if it has been looked into and there truly is no way to do it. >> >> I have some situations where I cannot get to my X310s easily, so if I >> need to reflash the bitfile (which is going to be necessary for RFNoC >> flowgraphs, I will have to add an external appliance to get the job >> done. I was thinking about looking into it, but if it already has and was >> deemed a non-starter, I don't want to waste the cycles. >> _______________________________________________ >> USRP-users mailing list >> USRP-users@lists.ettus.com >> http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com >> > > _______________________________________________ > USRP-users mailing list > USRP-users@lists.ettus.com > http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com > >
_______________________________________________ USRP-users mailing list USRP-users@lists.ettus.com http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
