Hello,
I am modifying the FPGA code (from version 7.0) for the B205mini.
I would like to control the GPIO pins from the FPGA code.
Control via the example GPIO host executable works fine.
I have tried hijacking the function in "radio_legacy.v" which I think is
controlling them.
generate
if (FP_GPIO != 0) begin: add_fp_gpio
gpio_atr #(.BASE(SR_FP_GPIO), .WIDTH(10), .FAB_CTRL_EN(0) ) fp_gpio_atr
(.clk(radio_clk),.reset(radio_rst),
.set_stb(set_stb),.set_addr(set_addr),.set_data(set_data),
.rx(run_rx), .tx(run_tx),
.gpio_in(fp_gpio_in), .gpio_out(fp_gpio_out),
.gpio_ddr(fp_gpio_ddr),
.gpio_out_fab(10'h000 /* no fabric control */),
.gpio_sw_rb(fp_gpio_readback));
end
endgenerate
In particular replacing the fp_gpio_out with my own register.
But so far all that does is cause the host GPIO program to no longer be able to
control the pins (as expected), but the FPGA values are not coming out either.
I would appreciate any examples, hints, tips/tricks to get this to work.
Thanks,
Ken Clark
_______________________________________________
USRP-users mailing list
[email protected]
http://lists.ettus.com/mailman/listinfo/usrp-users_lists.ettus.com
