I am having a similar issue. I have an Octoclock-G that is a bit older. I followed the steps to reflash the MCU using the Altera-ICE programmer, enabling Ethernet access in the older device. I have a similar issue to Bob where I still can't see the GPSDO sensor in the probe. Are there any legacy tricks for this?
Thanks, Pat On Mon, Jul 19, 2021 at 2:00 PM Tillson, Bob (US) via USRP-users < [email protected]> wrote: > I have an octoclock-g with gps lock light on and all other lights > functioning “normally”. > > > > I want to get nmea strings from it, but when I probe it, it tells me there > is no gpsdo J > > > > See below, any thoughts? > > > > uhd_usrp_probe --args type=octoclock,addr=192.168.100.134 > > [INFO] [UHD] linux; GNU C++ version 4.8.5 20150623 (Red Hat 4.8.5-39); > Boost_105300; UHD_3.14.1.1-0-unknown > > [INFO] [OCTOCLOCK] Opening an OctoClock device... > > [INFO] [OCTOCLOCK] Detecting internal GPSDO... > > [INFO] [GPS] No GPSDO found > > [WARNING] [OCTOCLOCK] Device reports that it has a GPSDO, but we cannot > communicate with it. > > [INFO] [OCTOCLOCK] Detecting external reference...false > > [INFO] [OCTOCLOCK] Detecting switch position...Prefer external > > [INFO] [OCTOCLOCK] Device is using internal reference > > _____________________________________________________ > > / > > | Device: OctoClock Device > > | _____________________________________________________ > > | / > > | | Mboard: OctoClock > > | | mac-addr: 00:80:2f:24:79:e3 > > | | ip-addr: 192.168.100.134 > > | | gateway: 192.168.100.1 > > | | netmask: 255.255.255.0 > > | | serial: 3183E75 > > | | revision: 4 > > | | FW Version: 3 > > | | > > | | Sensors: ext_ref_detected, gps_detected, using_ref, switch_pos > > > > > _______________________________________________ > USRP-users mailing list -- [email protected] > To unsubscribe send an email to [email protected] >
_______________________________________________ USRP-users mailing list -- [email protected] To unsubscribe send an email to [email protected]
