On 03/10/2024 16:49, [email protected] wrote:
Upon power up, the Octoclock should show all green LEDs on to the
left. After several seconds, the “External” LED should turn off, and
the PPS should begin to blink once per second. Instead ,this Octoclock
simply goes frozen in a state in which the “Internal” “External” and
“Status” LEDs remain stuck on. Nothing occurs after an hour of
waiting. The stuck LEDs are shown in the attached image.
An oscilloscope was used to test the unit, and no signals are produced
by any output. No PPS signals are generated, no 10MHz are seen from
any of the front panel SMAs.
How should I proceed with troubleshooting this Octoclock?
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
The CDA-2990 is a clock *DISTRIBUTION* module. It has no built-in GPSDO
unit unless you have populated one.
https://www.ettus.com/all-products/octoclock/
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
