Hi Martin If I run the command without changing the file parameters I get the error ERROR: [ Synth 8-448] named port connection 'gtrefclk' does not exist for instance 'core_support_i' of module 'one_gig_eth_pcs_pma_support' ERROR: [ Synth 8-448] named port connection 'gtrefclk_bufg' does not exist for instance 'core_support_i' of module 'one_gig_eth_pcs_pma_support' ERROR: [ Synth 8-6156] failed synthesizing module 'one_gige_phy' ERROR: [ Synth 8-6156] failed synthesizing module 'x300_sfpp_io_core' ERROR: [ Synth 8-6156] failed synthesizing module 'x300' ERROR[Common 17-69] ...
if I change the clk_domains and add : srcblk:_device_, srcport:ce, dstblk:gain0, dstport: ce I get the error: [ERR] 1 Unresolved clk domain(s) [ERR] (_device_-> gain0-ce) [ERR] Source or destination domain not found if I change the clk_domains from ce to rfnoc_chdr I get the error: ERROR: [synth 8-1031] gain0_rfnoc_chdr_clk is not declare[../../x310_rfnoc_image_core.v:1216] ERROR: [Common 17-69] Command failed .. I tried more configurations but all don't work I can build images for RFNoC blocks (FFT, FIR, etc) but for OOT I don't. Thank you Elkana בתאריך יום ד׳, 18 בדצמ׳ 2024 ב-17:19 מאת Anderseck, Martin via USRP-users <[email protected]>: > Depending on what exactly doesn't work you can try to update the file > system on the device: > > > https://kb.ettus.com/USRP_N300/N310/N320/N321_Getting_Started_Guide#Updating_the_Linux_File_System > > > > You should be able to ssh into the system. If that works and only UHD is > unable to find the device then something is wrong with the hardware demon. > If you cannot even connect via ssh then it is most probably an issue with > the network connection. There is a serial console available which you can > use to debug in that case. This is explained in the knowledge base > article, too. > > > > /Martin > > > > *From:* Muhammed Mustaqim <[email protected]> > *Sent:* Wednesday, December 18, 2024 10:01 AM > *To:* [email protected] > *Subject:* [EXTERNAL] [USRP-users] USRPN310 not connecting > > > > Hi Everyone, I have USRP N310, when I connect it to my laptop/PC it is > not showing > > Hi Everyone, > > I have USRP N310, when I connect it to my laptop/PC it is not showing that > it is connected, while the other One is connecting fine and I was able to > use it. > > > > Is there a way I can reset MY USRP N310?? > > > > > > Best Regards, > _______________________________________________ > USRP-users mailing list -- [email protected] > To unsubscribe send an email to [email protected] >
_______________________________________________ USRP-users mailing list -- [email protected] To unsubscribe send an email to [email protected]
