Hi
I am having the same problem using UHD 4.7 on a USRP-2974. Note I have also
used the JTAG recovery method to be sure, this works fine.
uhd_usrp_probe loads ok too. But when I use uhd_image_loader then there is a
problem
```
uhd_image_loader --args="type=x300,addr=192.168.40.2"
--fpga-path="x300_final.570080.bit"
```
```
[INFO] [UHD] linux; GNU C++ version 9.4.0; Boost_107100;
UHD_4.7.0.HEAD-0-a5ed1872
```
```
Unit: USRP NI-2974 (31D28CA, 192.168.40.2)
```
```
FPGA Image: /mnt/spirent/posapp/share/posapp/bitfiles/x300_final.570080.bit
```
```
failed.
```
```
Error: RuntimeError: Device reported an error during initialization.
Below is the output from reading the MB eeprom:
Fetching current settings from EEPROM...
EEPROM ["revision"] is "12"
EEPROM ["revision_compat"] is "7"
EEPROM ["product"] is "31131"
EEPROM ["mac-addr0"] is "00:80:2f:30:7b:5d"
EEPROM ["mac-addr1"] is "00:80:2f:30:7b:5e"
EEPROM ["gateway"] is "192.168.10.1"
EEPROM ["ip-addr0"] is "192.168.10.2"
EEPROM ["subnet0"] is "255.255.255.0"
EEPROM ["ip-addr1"] is "192.168.20.2"
EEPROM ["subnet1"] is "255.255.255.0"
EEPROM ["ip-addr2"] is "192.168.30.2"
EEPROM ["subnet2"] is "255.255.255.0"
EEPROM ["ip-addr3"] is "192.168.40.2"
EEPROM ["subnet3"] is "255.255.255.0"
EEPROM ["serial"] is "31D28CA"
EEPROM ["name"] is "98AC10626140838F"
Done
```
_______________________________________________
USRP-users mailing list -- [email protected]
To unsubscribe send an email to [email protected]
