Tom
I think your asking about the hose (line going to the master cylinder). Flat
washer,hose fitting,flat washer (new washers) but you have to follow the
torque specs.I don't have it in front of me but if your getting leakage not
enough torque.Use a torque wrench and that will scare you when you see how
much the manual states.
Bob H
"The Wild Cherry Max"
----- Original Message -----
From: <[EMAIL PROTECTED]>
To: V-MAX TECH LIST <[EMAIL PROTECTED]>
Sent: Thursday, June 08, 2000 9:05 PM
Subject: Brake Master cycl kit replacement
> Took out my brake M.C. kit about 6 months ago and want to make sure I'm
> putting it back correctly. I thought I did but I'm getting some leakage
out
> of the dust boot area. Is this do to incorrect seal placement? Are they
> supposed to go in with the flat ends against each other but separated by
the
> washer?
>
> Tom
> .............................................
> To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
> .............................................
.............................................
To unsubscribe go to http://www.sayegh.org/unsubscribe.htm
.............................................
