Hi All,
I use an USB DVB-T receiver. This works ok, but the snr meter at the bottom
of the screen is never filled more than a few pixels, no matter how good
the signal is. The problem with this receiver is that the snr figure never
goes above 0x00d0. Is there a way to adjust the scaling of the signal and
snr bars? I would like the snr bar to be fully filled when the figure is
0x00ff
Best regards,
Cedric
$ lsusb
Bus 001 Device 004: ID 2013:0245 PCTV Systems PCTV 73ESE
$ tzap -a 0 -r 'Nederland 1'
using '/dev/dvb/adapter0/frontend0' and '/dev/dvb/adapter0/demux0'
reading channels from file '/home/cedric/.tzap/channels.conf'
tuning to 474000000 Hz
video pid 0x1b63, audio pid 0x1b64
status 1b | signal 0dbd | snr 00a2 | ber 001fffff | unc 00000000 | FE_HAS_LOCK
$ dmesg
[ 3.519233] dvb-usb: found a 'Pinnacle PCTV 73e SE' in cold state, will
try to load a firmware
[ 3.529962] dvb-usb: downloading firmware from file 'dvb-usb-dib0700-1.20.fw'
[ 3.871202] dib0700: firmware started successfully.
[ 4.373456] dvb-usb: found a 'Pinnacle PCTV 73e SE' in warm state.
[ 4.373567] dvb-usb: will pass the complete MPEG2 transport stream to
the software demuxer.
[ 4.373732] DVB: registering new adapter (Pinnacle PCTV 73e SE)
[ 4.568680] DVB: registering adapter 0 frontend 0 (DiBcom 7000PC)...
[ 4.766795] DiB0070: successfully identified
[ 4.830021] Registered IR keymap rc-dib0700-rc5
[ 4.831325] input: IR-receiver inside an USB DVB receiver as
/devices/pci0000:00/0000:00:10.4/usb1/1-6/rc/rc0/input6
[ 4.831485] rc0: IR-receiver inside an USB DVB receiver as
/devices/pci0000:00/0000:00:10.4/usb1/1-6/rc/rc0
[ 4.831681] dvb-usb: schedule remote query interval to 50 msecs.
[ 4.831688] dvb-usb: Pinnacle PCTV 73e SE successfully initialized and
connected.
_______________________________________________
vdr mailing list
vdr@linuxtv.org
http://www.linuxtv.org/cgi-bin/mailman/listinfo/vdr
