I don't think timeouts to th client should cause a 84 error..but....you never know...
Jim -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On Behalf Of [EMAIL PROTECTED] Sent: Friday, January 06, 2006 7:11 PM To: [EMAIL PROTECTED]; [EMAIL PROTECTED] Cc: veritas-bu@mailman.eng.auburn.edu Subject: RE: [Veritas-bu] Problem getting file server backed up. code 84 A correction for the third condition is adding a larger value CLIENT_READ_TIMEOUT value to your bp.conf on your client. It'll make the media server more tolerant to slow conditions on the client. I find it especially valuable on my large database servers. I ahve a value of 10800 seconds per client as a matter of course now: CLIENT_READ_TIMEOUT = 10800 HTH -M -----Original Message----- From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] Behalf Of Ed Wilts Sent: Friday, January 06, 2006 7:41 AM To: Wooten, FH Frank (3934) @ IS Cc: veritas-bu@mailman.eng.auburn.edu Subject: Re: [Veritas-bu] Problem getting file server backed up. code 84 On Fri, Jan 06, 2006 at 08:10:56AM -0600, Wooten, FH Frank (3934) @ IS wrote: > Ok, I am having a huge problem getting a 400gb file server backed up. > My master server is a unix and the file server is win2k3. I have a > ESL9000 attached to a san switch that the file server is attached too. > Problem with > the job is it will run for 4 to 5 hours and then fail with a code 84 (media > write error). I have eliminated the tapes being the problem cause I > have used new tapes and still get this error. I am wondering if its > something with the switch or if it's the drives. It happens on > multiple drives not just one. > > Any help would be greatly appreciated. This is driving me nutts. I've seen at least 3 different classification of 84 errors: 1. Bad tape or tape drive. You've eliminated this. 2. A full disk staging unit. You're not using DSSUs. 3. Connectivity issues between media server and tape drive. This is where the fun happens... Check your switch ports for errors on the ports. I had this happen when I had my ISLs set for 2Gbps and found out later that the fibre wasn't capable of being driven at 2Gbps for that distance. I dropped my ISL speed to 1Gbps and it's working fine (still out of spec and giving me buffer credit issues but error-free from the backup point of view). My fibre is actually being replaced now. Have a good look at your SAN switch logs and the host error logs. When I had my issue, I was logging scsi errors on the hosts (even though the drives are on the other end of a fibre/scsi bridge). .../Ed -- Ed Wilts, Mounds View, MN, USA mailto:[EMAIL PROTECTED] _______________________________________________ Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu _______________________________________________ Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu _______________________________________________ Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu