Speaking of mapping patch, I noticed that mapping patch that I downloaded last month, was an older version than what was shipped with 6.5.3 patch. So I had to discard the mapping patch and just went with 6.5.3 mappings. In my case i only have LTO3 drives with an older library and all entries were there.
--- On Tue, 4/21/09, bob944 <bob...@attglobal.net> wrote: > From: bob944 <bob...@attglobal.net> > Subject: Re: [Veritas-bu] New Library Configuration Parameters > To: veritas-bu@mailman.eng.auburn.edu > Date: Tuesday, April 21, 2009, 8:14 AM > > Hello, my department just bought a new Spectra Logic > tape > > library and I'm tasked with installing it. Where > do I get > > the information for the configuration parameters like > robot > > type, drive type, etc? Is the provided by Spectra > Logic or > > Symantec? > > You shouldn't need to. The device configuration wizard > does a very > good job of figuring this out. Read the manual or just > click your > way through the startup screen steps. > > Patch after installation and before doing any setup. This > includes > the Mappings patch. > > > _______________________________________________ > Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu > http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu _______________________________________________ Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu