KinAn, base on my experience, since you need to enable mpxio for disk redundancy, you can't use the same port to connect to SL48, because SL48 infrastucture has daisychain between robotic and tape drive, this mean mpxio must be disable. if your SL48 has 2 tape drives, you can try to define which tape drive has daisychain to the robotic then use the another free hba port to connect to this drive... again.. dont forget to disable mpxio at fc.conf file only to hba port use for tape device.
hope this help. Regards, hmw ----- Original Message ----- From: KinAn <netbackup-fo...@backupcentral.com> Date: Wednesday, August 19, 2009 10:47 am Subject: [Veritas-bu] Solaris 10 run Netbackup cannot detect Sun StorageTekSL48?? > > But, I connect every over SAN. How to config like you talk? ( Mr > Hermawan) > Backup server ( port1), 6140 ( Controller A ), SL48 ( Driver 1) > connect to SAN SW 1 > > Backup server ( port2), 6140 ( Controller B ), SL48 ( Driver 2) > connect to SAN SW 1 > > Please help me. Backup server still free 1 port on HBA > > +------------------------------------------------------------------- > --- > |This was sent by kinan_kaz...@yahoo.com via Backup Central. > |Forward SPAM to ab...@backupcentral.com. > +------------------------------------------------------------------- > --- > > > _______________________________________________ > Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu > http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu > _______________________________________________ Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu