It turned out rpcbind was not setup correctly. This is a note that the Sun Engineer sent me:
Symptoms Although RPC is enabled on the ACSLS server, RPC clients cannot communicate to it. rpcinfo, when called from the client server, fails with an "Authentication error". # rpcinfo -p acsls_hostname rpcinfo: can't contact portmapper: RPC: Authentication error; why = Failed (unspecified error) Changes New clustered servers with Solaris OS, Solaris Cluster, ACSLS and ACSLS HA installed successfully. Cause rpcbind service was configured to have SMF property config/local_only set to TRUE. (By, default, it should be set to FALSE.) This SMF property is used to allow or disallow access to rpcbind by remote clients. Thus, a value of TRUE will disallow remote access. Solution 1. Verify the RPC bind service's local_only property setting: # svccfg -s bind listprop | grep local config/local_only boolean true 2. If set to TRUE, change the setting to FALSE; then, list the property again to verify change: # svccfg -s bind setprop config/local_only=false # svccfg -s bind listprop | grep local config/local_only boolean false 3. Refresh the service to activate the new value: # svcadm refresh bind -----Original Message----- From: veritas-bu-boun...@mailman.eng.auburn.edu [mailto:veritas-bu-boun...@mailman.eng.auburn.edu] On Behalf Of John Meyers Sent: Monday, October 03, 2011 3:48 PM To: Rusty Major Cc: VERITAS-BU@mailman.eng.auburn.edu Subject: Re: [Veritas-bu] ACSLS 8.0.2 and NBU 7.1(.0.2) Just a data point for you. We're still on ACSLS 7.3 under Solaris 10 and have had zero issues going from 6.5.4 -> 7.0 -> 7.0.1 -> 7.1 -> 7.1.0.1. The robot definitions were defined soley through the gui after the initial 7.0 upgrade and don't have anything specific to the robot in the vm.conf. John On 10/03/2011 02:03 PM, Rusty Major wrote: > Hi All, > > > > Fresh install of NBU 7.1 with ACSLS 8.0.2, both on Solaris 10. I am > unable to get NBU to communicate with ACSLS without forcing the port > to communicate over in vm.conf (ACS_CSI_HOSTPORT). This works fine until the ACSLS application is restarted and the port changes. > > > I noticed with NBU version 7.1.0.0, MM and ACS daemons would not even > start up, but when I patched to 7.1.0.2, all the appropriate daemons > started, but there was still no communication with ACSLS without the above mentioned vm.conf entry. ACSLS is configured with default settings. > > > > I have an ACSLS 8.0.2 server working with NBU version 6.5.x without > any issues (same default ACSLS settings and no entries in VM.CONF). > > > > Has anyone run across this and have any pointers? > > Thanks, > > -Rusty > > > > _______________________________________________ > Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu > http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu _______________________________________________ Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu _______________________________________________ Veritas-bu maillist - Veritas-bu@mailman.eng.auburn.edu http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu