> -----Original Message----- > From: [EMAIL PROTECTED] > [mailto:[EMAIL PROTECTED] On Behalf Of Rob Nielsen > Sent: Wednesday, 23 July 2003 12:05 PM > To: [EMAIL PROTECTED] > Subject: SAA7134 Sound disappeared > > > Hi. I am running two SAA7134 based Flyvideo 3000 cards > (Australia PAL > BG/DK) under Gentoo and up till now I have been having the > same problems > as Christian Hack in "SAA7134 - No audio via DSP _or_ card > output and > others" - ie sound disappearing on some recordings in MythTV > but now I > have another problem. >
I'm in Brisbane :) > I downloaded the 0.2.8 version of the SAA7134 drivers and when I > installed them, I couldn't get any sound out of the cards at > all. Then > I did a make install on the old 0.2.7 files again and it worked again > (as well as it did before anyway). Then I made a copy of the 0.2.7 > directory and did a make clean / make / make install on that > and I get > no sound again so it seems to be a problem with the way the > modules are > being compiled. The original compiled versions still work and there > aren't any errors reported when compiling. I did try using the 0.2.8 release after the 0.2.7 release and the current snapshot (dated 170703 I think) with no difference between the 3. It appeared that sometimes I'd get sound and sometimes I wouldn't. However, everynow and again, it will get to a point where where I can't get any sound at all and can only get it working when I remove and reload the modules. > > The only thing I can think of is that recently emerge upgraded my > version of gcc from 3.2.2 to 3.2.3-r1 and glibc from 2.3.1-r4 to > 2.3.2-r1. Could this explain the lack of sound? Picture and > tuning all > work fine but there is no sound (even with a speaker attached > directly > to the card output) no matter how many times I try. I have > rebuilt the > kernel too but this seems to make no difference. I found that when the sound wouldn't work in recording (either via /dev/dspx OR the direct output), it quite often would work via the direct output when I dropped back to the menu suggesting some sort of mute toggle not always toggling properly. I do however usually get sound after a number of retries. > > This is not a sound output issue as previous recordings play > back fine. Ditto I'm currently trying to get a SAA7134 programming manual through some contacts of mine (I'm an electrical engineer). If I could just get this little prob sorted I'd be so happy. CH -- video4linux-list mailing list Unsubscribe mailto:[EMAIL PROTECTED] https://www.redhat.com/mailman/listinfo/video4linux-list
