Eric, If you can get the screw out and it is damaged and you can't find a correct replacement, contact me off line and I'll send you one. :o)
Larry in Scottsdale, AZ "Always Learning" ----- Original Message ----- From: "Eric Ridvan Üner" <[EMAIL PROTECTED]> To: "Air-Cooled Volkswagen Discussion List" <[email protected]> Sent: Sunday, March 25, 2007 5:23 PM Subject: [vintagvw] Frozen Bolt Near Painted Surface The screw at the bottom of one of my headlights won't turn. Ordinarily I would spray it with something and try again in a few hours, but how does Tri-flow or similar effect painted surfaces? Any suggestions on what to use/do? I could drill it out but I'm not sure where I'd get another screw for a 65 headlight without getting an entire assembly (besides going to the hardware store and hunting for a close match). Thank in advance for any Advice, Doc
_______________________________________________ vintagvw site list [email protected] http://lists.sjsu.edu/mailman/listinfo/vintagvw
