On Thu, Sep 01, 2022 at 05:10:38AM +0300, Gavin Li wrote: > Currently add_recvbuf_big() allocates MAX_SKB_FRAGS segments for big > packets even when GUEST_* offloads are not present on the device. > However, if guest GSO is not supported, it would be sufficient to > allocate segments to cover just up the MTU size and no further. > Allocating the maximum amount of segments results in a large waste of > buffer space in the queue, which limits the number of packets that can > be buffered and can result in reduced performance. > > Therefore, if guest GSO is not supported, use the MTU to calculate the > optimal amount of segments required. > > When guest offload is enabled at runtime, RQ already has packets of bytes > less than 64K. So when packet of 64KB arrives, all the packets of such > size will be dropped. and RQ is now not usable. > > So this means that during set_guest_offloads() phase, RQs have to be > destroyed and recreated, which requires almost driver reload. > > If VIRTIO_NET_F_CTRL_GUEST_OFFLOADS has been negotiated, then it should > always treat them as GSO enabled. > > Accordingly, for now the assumption is that if guest GSO has been > negotiated then it has been enabled, even if it's actually been disabled > at runtime through VIRTIO_NET_F_CTRL_GUEST_OFFLOADS. > > Below is the iperf TCP test results over a Mellanox NIC, using vDPA for > 1 VQ, queue size 1024, before and after the change, with the iperf > server running over the virtio-net interface. > > MTU(Bytes)/Bandwidth (Gbit/s) > Before After > 1500 22.5 22.4 > 9000 12.8 25.9 > > Signed-off-by: Gavin Li <gav...@nvidia.com> > Reviewed-by: Gavi Teitz <g...@nvidia.com> > Reviewed-by: Parav Pandit <pa...@nvidia.com> > Reviewed-by: Xuan Zhuo <xuanz...@linux.alibaba.com> > Reviewed-by: Si-Wei Liu <si-wei....@oracle.com>
OK I think the logic is correct, it's just a bit harder to read than necessary. Small improvement suggestions: > --- > changelog: > v4->v5 > - Addressed comments from Michael S. Tsirkin > - Improve commit message > v3->v4 > - Addressed comments from Si-Wei > - Rename big_packets_sg_num with big_packets_num_skbfrags > v2->v3 > - Addressed comments from Si-Wei > - Simplify the condition check to enable the optimization > v1->v2 > - Addressed comments from Jason, Michael, Si-Wei. > - Remove the flag of guest GSO support, set sg_num for big packets and > use it directly > - Recalculate sg_num for big packets in virtnet_set_guest_offloads > - Replace the round up algorithm with DIV_ROUND_UP > --- > drivers/net/virtio_net.c | 37 ++++++++++++++++++++++++------------- > 1 file changed, 24 insertions(+), 13 deletions(-) > > diff --git a/drivers/net/virtio_net.c b/drivers/net/virtio_net.c > index f831a0290998..dbffd5f56fb8 100644 > --- a/drivers/net/virtio_net.c > +++ b/drivers/net/virtio_net.c > @@ -225,6 +225,9 @@ struct virtnet_info { > /* I like... big packets and I cannot lie! */ > bool big_packets; > > + /* number of sg entries allocated for big packets */ > + unsigned int big_packets_num_skbfrags; > + > /* Host will merge rx buffers for big packets (shake it! shake it!) */ > bool mergeable_rx_bufs; > big_packets_num_skbfrags -> big_packet_num_skbfrags > @@ -1331,10 +1334,10 @@ static int add_recvbuf_big(struct virtnet_info *vi, > struct receive_queue *rq, > char *p; > int i, err, offset; > > - sg_init_table(rq->sg, MAX_SKB_FRAGS + 2); > + sg_init_table(rq->sg, vi->big_packets_num_skbfrags + 2); > > - /* page in rq->sg[MAX_SKB_FRAGS + 1] is list tail */ > - for (i = MAX_SKB_FRAGS + 1; i > 1; --i) { > + /* page in rq->sg[vi->big_packets_num_skbfrags + 1] is list tail */ > + for (i = vi->big_packets_num_skbfrags + 1; i > 1; --i) { > first = get_a_page(rq, gfp); > if (!first) { > if (list) > @@ -1365,7 +1368,7 @@ static int add_recvbuf_big(struct virtnet_info *vi, > struct receive_queue *rq, > > /* chain first in list head */ > first->private = (unsigned long)list; > - err = virtqueue_add_inbuf(rq->vq, rq->sg, MAX_SKB_FRAGS + 2, > + err = virtqueue_add_inbuf(rq->vq, rq->sg, vi->big_packets_num_skbfrags > + 2, > first, gfp); > if (err < 0) > give_pages(rq, first); > @@ -3690,13 +3693,27 @@ static bool virtnet_check_guest_gso(const struct > virtnet_info *vi) > virtio_has_feature(vi->vdev, VIRTIO_NET_F_GUEST_UFO); > } > > +static void virtnet_set_big_packets_fields(struct virtnet_info *vi, const > int mtu) > +{ > + bool guest_gso = virtnet_check_guest_gso(vi); > + > + /* If device can receive ANY guest GSO packets, regardless of mtu, > + * allocate packets of maximum size, otherwise limit it to only > + * mtu size worth only. > + */ > + if (mtu > ETH_DATA_LEN || guest_gso) { > + vi->big_packets = true; > + vi->big_packets_num_skbfrags = guest_gso ? MAX_SKB_FRAGS : > DIV_ROUND_UP(mtu, PAGE_SIZE); > + } > +} > + > static int virtnet_probe(struct virtio_device *vdev) > { > int i, err = -ENOMEM; > struct net_device *dev; > struct virtnet_info *vi; > u16 max_queue_pairs; > - int mtu; > + int mtu = 0; > I think it's better to drop this and instead just put the code where we already know the config. So: > /* Find if host supports multiqueue/rss virtio_net device */ > max_queue_pairs = 1; > @@ -3784,10 +3801,6 @@ static int virtnet_probe(struct virtio_device *vdev) > INIT_WORK(&vi->config_work, virtnet_config_changed_work); > spin_lock_init(&vi->refill_lock); > > - /* If we can receive ANY GSO packets, we must allocate large ones. */ > - if (virtnet_check_guest_gso(vi)) > - vi->big_packets = true; > - > if (virtio_has_feature(vdev, VIRTIO_NET_F_MRG_RXBUF)) > vi->mergeable_rx_bufs = true; > > @@ -3853,12 +3866,10 @@ static int virtnet_probe(struct virtio_device *vdev) > > dev->mtu = mtu; > dev->max_mtu = mtu; > - > - /* TODO: size buffers correctly in this case. */ > - if (dev->mtu > ETH_DATA_LEN) > - vi->big_packets = true; /* Size buffers to fit mtu. */ if (mtu > ETH_DATA_LEN) { vi->big_packets = true; vi->big_packets_num_skbfrags = DIV_ROUND_UP(mtu, PAGE_SIZE); } > } > > + virtnet_set_big_packets_fields(vi, mtu); > + and here: /* If device can receive guest GSO packets, allocate buffers for * packets of maximum size, regardless of mtu. */ if (virtnet_check_guest_gso(vi)) { vi->big_packets = true; vi->big_packets_num_skbfrags = MAX_SKB_FRAGS; } > if (vi->any_header_sg) > dev->needed_headroom = vi->hdr_len; > > -- > 2.31.1 _______________________________________________ Virtualization mailing list Virtualization@lists.linux-foundation.org https://lists.linuxfoundation.org/mailman/listinfo/virtualization