I am sending this again because I received delivery failure on original ----- Original Message ----- From: Jay Diamond To: [EMAIL PROTECTED] Sent: Monday, April 26, 2004 8:34 PM Subject: Can't get connection to remote server from behind wireless router/firewall
My configuration is as follows: Remote server (PC running XP) with VNC server running on it. A belkin wireless ADSL router with built in firewall at home with a dynamic IP address 3 PCs running 2000 and XP with wireless access going into the router allocated IP addresses using DHCP. I am using IPsec to secure the link. My problem is that I cannot get the VNC viewer to see the remote server I need to take control of. If I replace the wireless setup and put a wired modem in and a single PC connected then it works fine, however, as soon as I plug in the wireless router it all goes to pot. I guess that this may be a "port forwarding issue", hwever, on my firewall I can do two things - neither of which are very clearly documented or explained. 1) I could use a feature called application gateways which has the fields "trigger port" "trigger type" (TCP or UDP) and "public port", "public type" (CP or UDP). I don't know if this is what I should be changing and if so what I should be putting in. 2) There is another feature called "virtual servers" which has the following fields: "LAN IP address" "potocol type" (TCP or UDP) "LAN port" "Public port" Can anybody help me? _______________________________________________ VNC-List mailing list [EMAIL PROTECTED] To remove yourself from the list visit: http://www.realvnc.com/mailman/listinfo/vnc-list
