Hi Gang, i am trying to do the oscillator alignment on my 5200A which went ok until step 23 on page 4-56 when it states that you should get "total spread of approximately 13 mv" ie:- +7to -7 mv whereas i get +14 to -13mv for a total spread of 27 mv. My question is is the 13 mv total correct or should i get +- 13mv as in my case. Given that i have found several other mistakes in the service manual writings i was wondering if this may be also a mistake. If the total 13mv spread is correct it leads me down another rabbit hole. Any advice welcome. Ken Goodhew. _______________________________________________ volt-nuts mailing list -- [email protected] -- To unsubscribe send an email to [email protected] To unsubscribe, go to and follow the instructions there.
