On Sep 22, 2011, at 1:53 PM, Alan J Fletcher wrote:

At 02:26 PM 9/22/2011, Horace Heffner wrote:
Lewan couldn't use it?

I can't find his statement that he measured the outflow through the T-trap. I don't THINK I imagined it ....




I don't see how it is possible to get reasonable measurement using the T-trap. If you look at the film at around 3:50 you can see the T- trap is full. If you then look at 4:25 you can see the flow is very fast, and could fill up the T-trap in a few seconds at most. A small plastic container is being used by hand to capture the flow. Likely that was later weighed.

Here is the film URL:

http://www.nyteknik.se/nyheter/energi_miljo/energi/article3264362.ece

Here are the notes regarding water overflow:

20:50 Overflow was approximately 3,7 grams/s or 13 kg/hour. T2=29.3° C, T3=90.3°C.
20:55 Overflow decreases. T2=29.2°C, T3=93.4°C.
21:50 Liquid water at the outlet was measured and found to vary between 1.4 and 1.8 grams/s or from 5.0 to 6.5 kg/hour.

So, it was not your imagination the overflow was measured. My point (see below) was merely that the T-trap could not be used to make the overflow measurements, at least not accurately. Measuring required removing the hose and using a container to catch the flowing water. Very inconvenient to do frequently. The T-trap was highly under sized.




On Sep 22, 2011, at 1:26 PM, Horace Heffner wrote:


On Sep 22, 2011, at 11:39 AM, Alan J Fletcher wrote:

At 12:18 PM 9/22/2011, Peter Heckert wrote:
Fit a transparent silicone rubber hose to this steam outlet, so we can see the water overflow and remove all doubts.

He sort-of did this for Lewan's September demo. The white section at the outlet has a transparent T-connection. (Video 4:22). Lewan said measuring the overflow at the T-trap gave the same results as disconnecting the hose entirely. I don't know why Lewan didn't measure the overflow at regular intervals.


The overflow was obviously much larger than expected. It looked like the T-trap would fill in seconds. It looked like it was a closed end T. If it were an open end T then the steam would pour out as well.



So .. Rossi made it available, Lewan didn't use it. Who's to blame?

Lewan couldn't use it?




Best regards,

Horace Heffner
http://www.mtaonline.net/~hheffner/




Reply via email to