*it should be noted that *high internal pressuriztion* may have the same
entropy reducing properties as very cold temperature. *

*With Pd the loading ratio must get near 1:1 before this becomes a factor.
Nickel alloys will load at ratios over 4:1 and this could be the single
most important reason that Ni-H works better than Pd, but it should be
noted that pure nickel does not load well at all ! Go figure.*


*Once again, this whole field seems to turn on minute spacing differentials
within a metal matrix, with FCC vacancies between 1-3 angstroms (100-300
picometers).*
*----------------------------------------*



*High hydrogen pressure is required in the gas envelope Rossi type reaction
vessel because this high pressure enables one of the essential mechanisms
in the Rossi LENR process: The prolific production of Rydberg atoms.*

 *Rydberg atoms are highly excited hydrogen atoms which have a very large
dipole moment. In these highly excited atoms, the electron obits are very
far from the hydrogen nucleus. This results in an extreme dipole moment
that is some ten times larger in magnitude than for an ordinary hydrogen
atom.*

 *This makes Rydberg atoms exquisitely sensitive to electrostatic forces.*

 *A bumpy metal surface is required to activate the Rossi process because
such a surface will ionize the exotic hydrogen Rydberg molecules that the
pressurized hydrogen envelope will produce. *

The bumpy, irregular, and undulating surface of a nickel lattices of the
Rossi micro powder will “field-ionized” these Rydberg atoms into highly
excited hydrogen ions that will lay directly on the surface of the micro
powder.

This phenomenon may be visualized as arising from the interaction of the
Rydberg atom with the electric fields produced by the irregular crystal
surface intentionally engineered on the surface of the micro powder. The
large variety of nickel nano-crystals found on such irregular surfaces will
generated an electrically disruptive electrostatic “image.”

 Compared to an ordinary hydrogen atom in the ground state, a highly
excited Rydberg atom has an extreme susceptibility to these irregular and
wildly varying electrostatic surface fields. This is because the Rydberg
electron experiences a greatly amplified dipole electric field due to their
larger average separation of the orbiting electron from the hydrogen
nucleus.

These polycrystalline metal surfaces of the nickel lattice will generate
inhomogeneous “patch” electric fields on the surface of the each and every
micro particle. This generates a huge catalytic spillover effect.

 These electrostatic fields influence Rydberg atoms causing both level
shifts and ionization and competing with the more intrinsic image charge
effects. In general, patch fields arise from the individual nano-grains of
a polycrystalline nickel lattice surface exposing a wide diversity of
crystal faces of the individual nano-crystals.

 *Each of these faces has a different widely varying work function due to
differing surface dipole layering.*

For example, Singh-Miller and Marzari have recently calculated the work
functions of the (111), (100), and (110) surfaces of gold and found 5.15,
5.10, and 5.04 eV, respectively. These differing work functions correspond
to potential differences just outside the surface beyond the dipole layer
that will rip the H2 molecule apart and completely ionize it.

 Consequently, charge density must be redistributed on the surface to
satisfy the electrostatic boundary conditions, producing very large
macroscopic electric fields.

 While patch fields were first discussed extensively in the context of
thermionic emission they are present near polycrystalline metal structures
of any type, including electrodes and electrostatic shields.

 A bumpy and lumpy nickel lattice surface provides Rydberg atoms with a
superior spill over ionization function of H2 hydrogen molecules as
compared to palladium and it keeps this ionization localized on the surface
of the nickel lattice.

 *If you are interested in this subject read this paper for more
theoretical background:*



http://arxiv.org/PS_cache/arxiv/pdf/1008/1008.1533v3.pdf

 Best regards:

Axil



On Sun, Jan 8, 2012 at 3:19 PM, Jones Beene <[email protected]> wrote:

> Speculation alert: Will development of the technology of hydrogen-loaded
> nickel usher in a new paradigm for going small - the "pico age"?
>
> The mention of Cooper pairing brings up potential correlations between high
> temperature superconductivity, matrix spacing, extreme loading and LENR. In
> regard to hydrogen loading, this pushes towards the sub-nanometer realm.
> Cooper pairing of nucleons and extreme loading was first mentioned on
> Vortex
> in 2004, if not further back. Needless to say, we are bit ahead of the
> curve, even if "pico" was almost unheard of then, and "nano" was all the
> rage.
>
> High loading can happen without Casimir cavities, but the highest possible
> loading may be contingent on proper interstitial spacing which is an order
> of magnitude tighter than "nano" of the Casimir variety - in the range of a
> few angstroms (hundreds of picometers). Further complicating the analysis -
> this ~250 pm ideal matrix spacing may require adjacent cavities (or pits)
> in
> the range of a few nm in order to "feed" in nucleons as they pair (or
> shrink, if you subscribe to Mills).
>
> Both Pd and palladium hydrides are superconductive at low temperature.
> Nickel and nickel oxides are superconductive at low temps. I do not have
> any
> information on nickel hydride superconductivity. This is probably due to a
> curious fact - nickel does not load well unless it is the major alloy with
> another metal which can "open up" the interstices by about 50-70 pm. As
> little as 5% of another transition metal seems to work "miracles" of
> loading
> with nickel.
>
> Here is a little-known factoid, should CF ever make it to "trivial pursuit"
> status - Laufer's "Theory of superconductivity in palladium-noble-metal
> hydrides" preceded P&F by three years. Another paper of interest: Lipson et
> al. Evidence of Super-stoichiometric H/D LENR Active Sites and High
> Temperature Superconductivity in a Hydrogen-Cycled Pd/PdO. Nice slides.
>
> http://lenr-canr.org/acrobat/LipsonAGevidenceofa.pdf
>
> Also, it should be noted that *high internal pressuriztion* may have the
> same entropy reducing properties as very cold temperature. With Pd the
> loading ratio must get near 1:1 before this becomes a factor. Nickel alloys
> will load at ratios over 4:1 and this could be the single most important
> reason that Ni-H works better than Pd, but it should be noted that pure
> nickel does not load well at all ! Go figure.
>
> Once again, this whole field seems to turn on minute spacing differentials
> within a metal matrix, with FCC vacancies between 1-3 angstroms (100-300
> picometers).
>
> We have only been fully immersed in the "nano-age" for a decade or two -
> and
> already it looks like Ni-H technology has the potential to usher in a
> "pico-age" !
>
> Nano - we hardly knew ya'.
>
> Jones
>
>
>
>

Reply via email to