It has been
several years ... I will need to look up my schematic for exact values.
It was
basically an LC parallel type tank circuit.
It was feed to 10 Mohm (I seem to recall) and voltage read across
that. It was in a 3 inch brass cylinder
hollowed out for the circuit with a BNC at the top to check via
an oscilloscope. The L was formed from
thin Pd wire that was electrochem loaded (wrapped around a glass tube filled
with Ni powder) before placing it in
the brass. The whole thing was sealed (O
rings and screwed down). (L, C, and R in // )
My idea at
the time was if the process caused any charged particle movements it should put
out shot noise
that would make the circuit “ring”. ….. Basically
an AC battery of sorts. It was OK for a
year or so then the signal died off. I
still have the thing over on a shelf.
Dennis> From: [email protected]
> To: [email protected]
> Subject: Re: [Vo]:D or H loading...and other questions..
> Date: Sat, 2 Mar 2013 14:18:57 +1100
>
> In reply to DJ Cravens's message of Tue, 26 Feb 2013 07:48:31 -0700:
> Hi D2,
> [snip]
> > There are
> >also loaded wire samples that are part of “tank circuits” that continue to
> >give
> >electrical currents (in the picowatt region) for months.
> >
> This interests me. Could you provide the schematic of the circuit?
>
> Regards,
>
> Robin van Spaandonk
>
> http://rvanspaa.freehostia.com/project.html
>