So, are we are suggesting instead a much thinner layer [.3g] spread over the 
entire inner surface of the reactor only? Or a foaming fixation that makes the 
nickel powder expand to fill the cavity ?

From: MarkI-ZeroPoint [mailto:[email protected]]
Sent: Wednesday, May 29, 2013 4:33 PM
To: [email protected]
Subject: RE: EXTERNAL: Re: [Vo]:Speculation about hotCat

Jed asked:
Question: assuming it really is 0.3 g, what is the likely volume?
Nowhere near enough to fill the cylinder.
*Why such a large cylinder?*

- most likely would be to get the necessary surface area to adequately transfer 
the heat from interior to exterior.

-mark

From: Jed Rothwell [mailto:[email protected]]
Sent: Wednesday, May 29, 2013 1:11 PM
To: [email protected]<mailto:[email protected]>
Subject: Re: EXTERNAL: Re: [Vo]:Speculation about hotCat

If the powder sinters, I suppose:

That's good because it is what makes the powder stick to the wall.

That's bad because it reduces surface area. This is what caused Arata's pure Pd 
black cells to stop working after a while.

Takahashi said it was not the high temperature but rather the chemical action 
of hydrogen on the metal that caused the particles to stick together.

I guess when they open the cell they have to scrape out the powder.

Question: assuming it really is 0.3 g, what is the likely volume? Nowhere near 
enough to fill the cylinder. Why such a large cylinder? Maybe because that's 
what he has in stock.

- Jed

Reply via email to