Shouldn't both interfaces be on separate subnets??? On Fri, 2011-05-06 at 17:38 -0700, Big Booger wrote: > Hi Punky > > I have attached the output from running the commands you recommended. > #ifconfig -a > #route -n. > > I didn't know what you meant by the serial console so I googled it. Tommorow > I > will try to get a cable and enable it and let you know. > > Thanx again, > > Matt > > root@voyage:~# ifconfig -a > ath0 Link encap:Ethernet HWaddr 06:02:6f:44:e1:3e > inet addr:192.168.1.2 Bcast:192.168.1.255 Mask:255.255.255.0 > inet6 addr: fe80::402:6fff:fe44:e13e/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:1522 errors:0 dropped:0 overruns:0 frame:0 > TX packets:6 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:93400 (91.2 KiB) TX bytes:1117 (1.0 KiB) > > eth0 Link encap:Ethernet HWaddr 00:0d:b9:1b:e3:e8 > inet addr:192.168.1.31 Bcast:192.168.1.255 Mask:255.255.255.0 > inet6 addr: fe80::20d:b9ff:fe1b:e3e8/64 Scope:Link > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:1978 errors:0 dropped:0 overruns:0 frame:0 > TX packets:1234 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:142546 (139.2 KiB) TX bytes:81661 (79.7 KiB) > Interrupt:10 Base address:0xa000 > > eth1 Link encap:Ethernet HWaddr 00:0d:b9:1b:e3:e9 > BROADCAST MULTICAST MTU:1500 Metric:1 > RX packets:0 errors:0 dropped:0 overruns:0 frame:0 > TX packets:0 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:1000 > RX bytes:0 (0.0 B) TX bytes:0 (0.0 B) > Interrupt:15 Base address:0xe000 > > lo Link encap:Local Loopback > inet addr:127.0.0.1 Mask:255.0.0.0 > inet6 addr: ::1/128 Scope:Host > UP LOOPBACK RUNNING MTU:16436 Metric:1 > RX packets:30 errors:0 dropped:0 overruns:0 frame:0 > TX packets:30 errors:0 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:0 > RX bytes:2442 (2.3 KiB) TX bytes:2442 (2.3 KiB) > > wifi0 Link encap:UNSPEC HWaddr > 00-02-6F-44-E1-3E-65-74-00-00-00-00-00-00-00-00 > UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 > RX packets:1933 errors:0 dropped:0 overruns:0 frame:12 > TX packets:126 errors:5 dropped:0 overruns:0 carrier:0 > collisions:0 txqueuelen:280 > RX bytes:317333 (309.8 KiB) TX bytes:9096 (8.8 KiB) > Interrupt:11 > > > root@voyage:~# route -n > Kernel IP routing table > Destination Gateway Genmask Flags Metric Ref Use Iface > 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 > 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 ath0 > 0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 ath0 > 0.0.0.0 192.168.1.1 0.0.0.0 UG 0 0 0 eth0 > > > > ----- Original Message ---- > From: Kim-man 'Punky' TSE <[email protected]> > To: Big Booger <[email protected]> > Cc: [email protected] > Sent: Fri, May 6, 2011 12:35:03 AM > Subject: Re: [Voyage-linux] Basic Wifi problem > > Hi Matt, > > This is the exactly the same config I have in my office eveyday, it works for > me > without problem. Can you show the > > output of: > > # ifconfig -a > # route -n > > To further troubshoot you should have enable serial console in ALIX box in > order > to see what happens. > > Regards, > Punky > > On 5/6/2011 12:53 PM, Big Booger wrote: > > Hi > > > > I am having some wifi problems with an Alix board and an athereos wifi mini > PCI > > card. I have voyage mpd 7.7.0 on the alix. I have the board running no > >problem > > through ethernet, and the wifi card scans (see iwlist below). Also when I > > run > > nmap on my network I get the ethernet connection showing and another address > > that I assume is the wifi connection. I can ssh into the wifi address (at > >least > > I assume it is the wifi address), but when I disconnect the ethernet cable > > my > > connection through the wifi address is disabled. Does anyone have any > > insight > > into what is going on here? I would like to have this alix board supply my > DAC > > and connect to my Arch Server through wifi - i do not want to have to have > > an > > ethernet cable permenently connected to the board. I have tried booting the > > board up with out an Ethernet cable connected, and nmap shows no new > connection > > onto my network. Any help is appreciated. > > > > I have attached some information below. Let me know if I should supply any > >more > > information. > > > > Regards, > > Matt > > > > > > > From running #iwlist ath0 scan > > Cell 02 - Address: 06:26:F2:F4:31:E5 > > ESSID:"TestMatt" > > Mode:Master > > Frequency:2.422 GHz (Channel 3) > > Quality=42/70 Signal level=-53 dBm Noise level=-95 > > dBm > > Encryption key:on > > Bit Rates:1 Mb/s; 2 Mb/s; 5.5 Mb/s; 11 Mb/s; 6 Mb/s > > 9 Mb/s; 12 Mb/s; 18 Mb/s; 24 Mb/s; 36 Mb/s > > 48 Mb/s; 54 Mb/s > > Extra:bcn_int=200 > > IE: IEEE 802.11i/WPA2 Version 1 > > Group Cipher : TKIP > > Pairwise Ciphers (2) : CCMP TKIP > > Authentication Suites (1) : PSK > > IE: WPA Version 1 > > Group Cipher : TKIP > > Pairwise Ciphers (2) : CCMP TKIP > > Authentication Suites (1) : PSK > > > > Extra:wme_ie=dd180050f2020101850003a4000027a4000042435e0062322f00 > > > > > > Interfaces file contents: > > # Used by ifup(8) and ifdown(8). See the interfaces(5) manpage or > > # /usr/share/doc/ifupdown/examples for more information. > > auto lo > > iface lo inet loopback > > > > auto eth0 > > iface eth0 inet dhcp > > > > auto ath0 > > iface ath0 inet dhcp > > madwifi-base wifi0 > > wireless-mode Managed > > wpa-conf /etc/wpa_supplicant/wpa_supplicant.conf > > > > > > Contents of wpa_supplicant.conf: > > network={ > > ssid="TestMatt" > > #psk="password" > > > > psk=96c98dc5ca179fe2286d29eb0dd5021ad44fac388c1aeae121b8de6e40e2fa65 > > key_mgmt=WPA-PSK > > proto=WPA > > # proto=RSN #uncomment for WPA2 > > } > > > > > > Output of # lspci > > 00:01.0 Host bridge: Advanced Micro Devices [AMD] CS5536 [Geode companion] > Host > > Bridge (rev 33) > > 00:01.2 Entertainment encryption device: Advanced Micro Devices [AMD] Geode > > LX > > AES Security Block > > 00:09.0 Ethernet controller: VIA Technologies, Inc. VT6105M [Rhine-III] > > (rev > >96) > > 00:0b.0 Ethernet controller: VIA Technologies, Inc. VT6105M [Rhine-III] > > (rev > >96) > > 00:0e.0 Ethernet controller: Atheros Communications Inc. AR5413 802.11abg > > NIC > > (rev 01) > > 00:0f.0 ISA bridge: Advanced Micro Devices [AMD] CS5536 [Geode companion] > > ISA > > (rev 03) > > 00:0f.2 IDE interface: Advanced Micro Devices [AMD] CS5536 [Geode > > companion] > >IDE > > (rev 01) > > 00:0f.4 USB Controller: Advanced Micro Devices [AMD] CS5536 [Geode > > companion] > > OHC (rev 02) > > 00:0f.5 USB Controller: Advanced Micro Devices [AMD] CS5536 [Geode > > companion] > > EHC (rev 02) > > > > _______________________________________________ > > Voyage-linux mailing list > > [email protected] > > http://list.voyage.hk/mailman/listinfo/voyage-linux > >
-- Steve Holdoway <[email protected]> http://www.greengecko.co.nz MSN: [email protected] Skype: sholdowa _______________________________________________ Voyage-linux mailing list [email protected] http://list.voyage.hk/mailman/listinfo/voyage-linux
