Hi, I tried to set up a MPD player with an Alix.3d3 board and a Wistron DNMA92 wireless card. I used MPD Voyage V0.9 and would like to access my music repository thru a wlan connection. The card got recognized ok and the ath9k driver is loaded at boot. I configured etc/network/interfaces and wpa_supplicant to access my WPA2 protected network. This seems to kind of work sometimes, but the authentication does not work right out and I don't get a DHCP response most of the times. It just keeps retrying and then connections only hold for a second before it starts all over again. I do need to set the router (zyxel) zu 20Mhz channel BW instead of 20/40Mhz - limiting the other clients. Otherwise I don't get a connaction at all. Eventually I might get a IP address but this is only pingable through the lan cable, if I disconnect the lan I loose the connection. I can't have two interfaces on the same network? The final setup would be without lan cable, but right now I need that to access system for configuration purposes.
1) is there an issue with hostapd? I do not want the sytem to be a AP, I just want to access my wlan network 2) do I need to configure the dnma92 card (channel, BW, tx power, other settings?) and where would I do this in Voyage? I would greatly appreciate if somebody who has set up a dnma92 card to access a wlan (802.11n if possible) network could post his / her settings ;-), I'am kind of lost right now. Thanks, Michael _______________________________________________ Voyage-linux mailing list Voyage-linux@list.voyage.hk http://list.voyage.hk/mailman/listinfo/voyage-linux