On 20-Feb-00, Len Harwood wrote:
> Hello,Until recently I have been using an Amiga 1200 with 340 H.D and
> 4 Meg expansion board this worked ok until I decide to register and
> upgrade to Voyager V3,this had the effect of dragging my memory down
> to about .2 Meg which meant that I can not get beyond the first page
> on the net,I was advised to get more memory so I invested in a 8 Meg
> accelerator board but now when I switch on the hard-drive does not
> seem to wind-up as it should
Can you give more information on the accelerator card? What processor
and speed is it? Manufacturer?
New or second-hand?
What happens when you boot from a Workbench 3 floppy disk? (Use a copy
of the disk, only use your original to make a working copy. Write
protect the original before you copy it.). Does the
hard drive then get recognised or not? Does it get recognised with the
old card but not the new one when booting from floppy?
Anything else plugged in, such as a Squirrel? Is the hard drive 3 1/2
ich or 2 inch? A big one might be drawing more current than the power
supply can deliver if you add an accelerator.
Even 8 Megs of RAM isn't much for a web browser, but the hard drive
should work.
Regards
--
Don Cox
[EMAIL PROTECTED]
____________________________________________________________
Voyager Mailing List - Info & Archive: http://www.vapor.com/
For Listserver Help: <[EMAIL PROTECTED]>, "HELP"
To Unsubscribe: <[EMAIL PROTECTED]>, "UNSUBSCRIBE"
