Hi Jack,
on Sun, 28 May 2000 at 13:19:56 you spoke about changing fonts and said:
>I downloaded most of the files. Haven't gone through it thoroughly
>yet but not to sure about the easy part you mention. It looks pretty
>convoluted on first pass. Thanks for the help.
Sorry for the delay in replying to your email but I have been having system probs.
Nothing to do the the fonts installation I might add :-)
It really is easy, honest. I have installed TT fonts, using the tutorial, on both V
and Ibrowse. Once you do V, doing Ibrowse is very similar.
I made sure that I had downloaded all the plain fonts, the TTF lib for my processor,
and the code page. All the links for these are on the tutorial page.
Then I disconnected from the Net and with the tutorial still displayed in V I started
to work through it. When the time came for a reboot, after after installing the
codepage I beleive, I just reloaded V and then loaded the tutorial from cache and
continued. Then it was just a matter of switching back and forth between V and the
Wbench screen in order to carry out the instructions.
As you have noticed, the font size to set for the make range command in V is the one
marked 'default', the third one down the list of each font, whereas for Ibrowse I used
the first font size in the list.
Just follow all the steps as written down, including doing the bitline bit at the end.
Hope that helps
--
A La Prochaine
Dave Le Huray
Guernsey, Channel Islands
ICQ: 56195074
- - Surfing the Net with the speed of a Pentium - -
- - - - On my dual 160/25Mhz Amiga 1200T :-) - - - -
--
_____________________________________________________________________
Voyager Mailing List - http://v3.vapor.com/
Voyager FAQ....: http://faq.vapor.com/voyager/
Listserver Help: mailto:[EMAIL PROTECTED]?Subject=HELP
Unsubscribe....: mailto:[EMAIL PROTECTED]?Subject=UNSUBSCRIBE
