On Thu, 27 Jan 2011 14:11:26 +0800 "Brown, Kevin (RTHQ)" <[email protected]> wrote:
> less, I have been successful in creating the connection and it > creates / established the tunnel ok. > > The problem I have, is that the traffic does not pass through to the > remote network over the VPN tunnel. If I ping a device or try to VNC > to a remote computer, it fails. I have specified the remote network > subnet in the policy tab. > Hi Kevin, I would first check to see if Phase2 security associations are being setup properly. Even though Phase2 negotiations complete and "Tunnel enabled" appears in the Shrew Connect dialog, it is possible that that SAs are failing. You can see the SA status using the VPN Trace utility on the Security Associations tab. This page provides steps to start logging using the Trace utility (remember to right-click and Run As Administrator in Vista/Win7): http://www.shrew.net/support/wiki/BugReportVpnWindows What you should see are two "MATURE" SAs setup shortly after you initiate traffic (for instance ping) toward the remote network. If you see them repeatedly going into LARVAL state, it means that something isn't quite matched up with your Shrew policy and the gateway policy. _______________________________________________ vpn-help mailing list [email protected] http://lists.shrew.net/mailman/listinfo/vpn-help
