Hi, > > I tried to build a vserver using: > > > > # ./vserver-build --force -m yum -n dns-int1 --hostname > > ns2-int.domain.dk --netdev=eth0:0 --interface=192.168.3.27 > > --netmask=255.255.255.0 -- -d wbel4 > > you certainly do not want to specify eth0:0 which isn't an > interface but at best an alias ... if you want to get an > alias (why would you need it for? ... ah ifconfig, I see :) > then better use something like: > > --interface hansi=eth0:192.168.3.27/24
I found out - it creates its own virtual interface ;-) Anyway - stopping the vserver still gives: > > # vserver dns-int1 stop > > Shutting down system logger: [ OK ] > > Starting killall: [ OK ] > > A timeout occured while waiting for the vserver to finish > and it was > > killed by sending a SIGKILL signal. Please investigate the reasons > > and/or increase the timeout in apps/vshelper/sync-timeout. Even though nothing particular has been started inside the vserver.. And one of the last things: If I need to run qmail inside one of the vservers, I guess it should be created with "--initstyle fakeinit" ?? As far as I remember, there is an issue with bind - it should have CAP_SYS_RESOURCE set (at least it was so in the old-style config). Where should this parameter be added in the 2.0-style configuration ? Regards, /Brian _______________________________________________ Vserver mailing list Vserver@list.linux-vserver.org http://list.linux-vserver.org/mailman/listinfo/vserver