It turns out that I did not have any definition file for init for this vserver. Is that normal? I made it plain init and this service ( watchdog which monitors and restarts dead services ) in plesk worked fine.
But now when I reboot inside the guest, it just shuts it down and does not restart it. -----Original Message----- From: Herbert Poetzl [mailto:[EMAIL PROTECTED] Sent: Friday, April 21, 2006 7:33 PM To: ehab heikal Cc: vserver@list.linux-vserver.org Subject: Re: [Vserver] Application problem, signal to init failed? On Fri, Apr 21, 2006 at 02:27:47PM +0200, ehab heikal wrote: > > I installed plesk 8 on a vserver and it is working ok till now. One > issue I have is that its watchdog which watches if services are up and > tries to automatically restart them is not working. It gives the > following error when I try to enable it. > > Error occurred while calling the module utility wdservice: 'Send > signal to init failed' are you sure that your guest has an init running and not such a fake-init blendthrough? (check the init stlye, sysv means fake, plain means real) HTH, Herbert > Seems like a capabilities problem. Does anyone have a clue which > Capability might cause a signal to init to fail? > > I have the following caps enabled. > CAP_NET_BIND_SERVICE > CAP_NET_BROADCAST > CAP_NET_ADMIN > CAP_NET_RAW > CAP_SYS_ADMIN > CAP_SYS_RESOURCE > CAP_SYS_TIME > CAP_SETPCAP > CAP_LINUX_IMMUTABLE > > _______________________________________________ > Vserver mailing list > Vserver@list.linux-vserver.org > http://list.linux-vserver.org/mailman/listinfo/vserver _______________________________________________ Vserver mailing list Vserver@list.linux-vserver.org http://list.linux-vserver.org/mailman/listinfo/vserver
