Hi Tim

Generally I use the bottom slot, as that tends to be the first one it checks. 
(And Apple ship in the bottom two by default,..so I assume that first one is 
the first one it checks).
Kind regards
Daniel

---
Daniel Kerr
MacWizardry

Phone: 0414 795 960
Email: <daniel AT macwizardry.com.au>
Web:   <http://www.macwizardry.com.au>


**For everything Apple**

NOTE: Any information provided in this email may be my personal opinion and as 
such should be taken accordingly, and may not be the views of MacWizardry. Any 
information provided does not offer or warrant any form of warranty or accept 
liability. It would be appreciated that if any information in this email is to 
be disseminated, distributed or copied, that permission by the author be 
requested. 

> On 29 Oct 2020, at 9:23 pm, Tim Law <t...@peoplehelp.com.au> wrote:
> 
> Always helpful Daniel
> 
> Does it matter which slot I have the RAM in?
> 
> 
> 
> Tim's red iPhone 
> 
>> On 29 Oct 2020, at 9:12 pm, Daniel Kerr <dan...@macwizardry.com.au> wrote:
>> 
>> Hi Tim
>> 
>> When you removed and replaced the RAM, did you put it all back or test it 
>> separately?
>> That would be one check, is just run it on one stick of RAM at a time. It 
>> will be slow, but this can narrow down if a stick is faulty.
>> 
>> Also, you can check the drive as well to ensure that’s ok.
>> I recommend the following SMART Utility. (You can run it in Shareware mode)
>> https://www.volitans-software.com/apps/smart-utility/
>> This will check the drives and advise is “Passed” (green), “Failing” 
>> (orange) or “Failed” (red). It works with Fusion Drives as well and will 
>> test both HDD and SSD separately.
>> I’ve used it to find faulty drives even before Apple Disk Utility finds 
>> them. So it’s a good little tool.
>> 
>> That would be my first things to try anyway, just to rule out a stick of RAM 
>> and drive is ok.
>> Also try an SMC reset and PRAM reset. (I have steps on my FAQ page of my 
>> website if you’re not familiar with that.
>> 
>> Try those and see how you go.
>> If no success, and seeing you’re up Duncraig way I’d recommend MacWorx 
>> Joondalup. (Delage Street, Joondalup) - www.macworx.com.au
>> 
>> Hope something there helps.
>> Kind regards
>> Daniel
>> 
>>  Sent from my iPhone 12 Pro 
>> 
>> ---
>> Daniel Kerr
>> MacWizardry
>> 
>> Phone: 0414 795 960
>> Email: <daniel AT macwizardry.com.au>
>> Web:   <http://www.macwizardry.com.au>
>> 
>> 
>> **For everything Apple**
>> 
>> NOTE: Any information provided in this email may be my personal opinion and 
>> as such should be taken accordingly, and may not be the views of 
>> MacWizardry. Any information provided does not offer or warrant any form of 
>> warranty or accept liability. It would be appreciated that if any 
>> information in this email is to be disseminated, distributed or copied, that 
>> permission by the author be requested. 
>> 
>>> On 29 Oct 2020, at 8:39 pm, Tim Law <t...@peoplehelp.com.au> wrote:
>>> 
>>> Hello folks.
>>> 
>>> I have an unhappy iMac (Retina 5K, 27-inch, 2017)
>>> 40Gb RAM
>>> 10.15.7
>>> 
>>> 
>>> Problem is random restarts.
>>> First symptom is the mouse freezes then about 30 seconds later the computer 
>>> turns off and restarts.  This happens enough to be very annoying, and has 
>>> occurred whilst I was drafting this message. 
>>> 
>>> The problem first occurred after I had transported the computer, screen 
>>> down, on the seat of my car. No physical external damage is apparent. 
>>> 
>>> 
>>> Problem does occur in Safe Boot mode, though not as frequently as in normal 
>>> mode. 
>>> 
>>> EtreCheck shows nothing out of order
>>> Rebooting into recovery mode and running both Disk Utility and reload 
>>> latest operating system have been done. 
>>> 
>>> *** MCA Error Report ***
>>> CPU Machine Check Architecture Error Dump (CPU: Intel(R) Core(TM) i5-7500 
>>> CPU @ 3.40GHz, CPUID: 0x906E9)
>>> CATERR detected! No MCA data found.
>>> 
>>> 
>>> I had assumed it was a hardware problem triggered by moving the machine but 
>>> nothing is showing up in any errors that I have seen.  I have removed and 
>>> replaced the RAM.   When running, it functions normally as expected. 
>>> 
>>> Any thoughts on what else I could do before taking it to the doctor?
>>> Which doctor is recommended. 
>>> I live in Duncraig area. 
>>> 
>>> 
>>> 
>>> Thanks
>>> 
>>> 
>>> 
>>> 
>>> 
>>> -- The WA Macintosh User Group Mailing List --
>>> Archives - <http://www.wamug.org.au/mailinglist/archives.shtml>
>>> Guidelines - <http://www.wamug.org.au/mailinglist/guidelines.shtml>
>>> Settings & Unsubscribe - 
>>> <http://lists.wamug.org.au/listinfo/wamug.org.au-wamug>
>> 
>> -- The WA Macintosh User Group Mailing List --
>> Archives - <http://www.wamug.org.au/mailinglist/archives.shtml>
>> Guidelines - <http://www.wamug.org.au/mailinglist/guidelines.shtml>
>> Settings & Unsubscribe - 
>> <http://lists.wamug.org.au/listinfo/wamug.org.au-wamug>
> 
> -- The WA Macintosh User Group Mailing List --
> Archives - <http://www.wamug.org.au/mailinglist/archives.shtml>
> Guidelines - <http://www.wamug.org.au/mailinglist/guidelines.shtml>
> Settings & Unsubscribe - 
> <http://lists.wamug.org.au/listinfo/wamug.org.au-wamug>

-- The WA Macintosh User Group Mailing List --
Archives - <http://www.wamug.org.au/mailinglist/archives.shtml>
Guidelines - <http://www.wamug.org.au/mailinglist/guidelines.shtml>
Settings & Unsubscribe - <http://lists.wamug.org.au/listinfo/wamug.org.au-wamug>