I need assistance to figure out where to look for a problem with "ignore_zero_wind". (and interceptor)
I have five Raspberry Pi's at three physical locations: zero, 3B+ and 4. All are running 05/2020 OS Four are running Weewx 4.1.1, one is 3.9.2 All have the same issue. At my remote locations Weewx runs in parallel with Meteobridge, both receiving the same data through a GW1000, from WS-2902 arrays. Meteobridge never shows 0 for wind_dir. I would prefer consistancy between the two systems. My bad windir data comes out in three ways: "0" from my output extensions, cwxn and weewx2aprx "NaN" from W34 charts "None" from a custom Seasons report file Three different output methods allowed me to conclude it wasn't the output. I added "ignore_zero_wind" with no effect. Nothing unusual in the logs. I studied previous posts with the same issue and saw suggestions to run weewxd. When I did, in the loop packets I saw "none" as wind_dir when wind speed was 0 My suspicion is that if the loop packet has "none" it isn't weewx, more likely the interceptor. Is that correct? So I'm trying to run weewx-interceptor directly, which in my case was given as PYTHONPATH=bin python bin/user/interceptor.py --device=fineoffset-bridge --mode=listen --port=8007 I used /usr/share/weewx/user/interceptor.py and got an error in line 302, "Import Error: no module named weewx.drivers". So I tried interceptor.py --help, as suggested in github, and got the same error. Since I'm so all over the place I haven't yet attached logs or configs yet. I need direction. -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to weewx-user+unsubscr...@googlegroups.com. To view this discussion on the web visit https://groups.google.com/d/msgid/weewx-user/47caf7ab-7223-4c6f-b178-668d410296f2n%40googlegroups.com.