Well, to make a long story (a couple of days) short: After upgrading my Raspi to Raspian Trixie, i first stayed with Weewx 5.1, until I got it running properly, as all to be done, I read the hints in the weewx wiki - afterwards… Then I wanted to update to version 5.2 in the regular way. After updating, I played back the backup for the weewx database and started the new 5.2 version. However, it had changed unexpectedly the driver from my old gw1000 to simulator. I immediately stopped weewx, replaced the weewx.conf with the previous 5.1 version and established the only obvious diff entry, for the new version. Then restarted. Everything looked fine, as there were no obvious data from the simulator existent. No, after a few days I checked the entries in the seasons skin and detected additional sensor entries with no data, such as signal quality and some others. These entries seem not to disappear, when no data come in. It is just cosmetic, but what would be the best way to clean up the presentation in the skin? I could, as in former days, explicitely enter only those sensors in the skin, which I have. Or, is there an easy way to delete the dummy simulator entries from the database and leave the more sophisticated skin as is?
Sorry for bothering you, because I was too lazy while upgrading. Any ideas are welcome Peter -- You received this message because you are subscribed to the Google Groups "weewx-user" group. To unsubscribe from this group and stop receiving emails from it, send an email to [email protected]. To view this discussion visit https://groups.google.com/d/msgid/weewx-user/c32befec-bfd3-4d0e-b7c4-80e529ca60a4n%40googlegroups.com.
