Hi Miki I'm doing basically what your talking about but with OSPF.
I do not use wg-quick, instead I configure the Wireguard in the network interface file like /etc/network/interface on all the machines. iface wg-p2p inet static address xxx.xxx.xxx/xxx pre-up ip link add $IFACE mtu 1500 type wireguard pre-up wg setconf $IFACE /etc/wireguard/$IFACE.conf post-down ip link del $IFACE Central machines I'll list the allowed ip addresses from the individual peers. On the peers I'll have an allow all like AllowedIPs = 0.0.0.0/0, ::/0 The allow all ip's on each peer does not add a route but does allow any traffic to be sent to the central system. >From that point you can configure any dynamic routing system you want. Mike On 17/1/20 9:23 pm, Roberto 007 wrote: > Hello Wireguard team, > > I would like to test multiple VPN links with BGP which is for > controlling traffic. > I have no problem to make BGP over multiple links but once I tried to > ping then I found a problem because I cannot set Allowed-IPs 0.0.0.0/0 > <http://0.0.0.0/0> to all the wireguard links. > > My question is that this kind of configuration is not supported > wireguard? > > I could make it with IPSec without any issues. > > If you could give us some advice, it would be greatly appreciated. > > Thanks and best regards, > Miki > > > _______________________________________________ > WireGuard mailing list > WireGuard@lists.zx2c4.com > https://lists.zx2c4.com/mailman/listinfo/wireguard
_______________________________________________ WireGuard mailing list WireGuard@lists.zx2c4.com https://lists.zx2c4.com/mailman/listinfo/wireguard