Travis, What is the Manuf, Model of these gel cels, and where do you get them. additionally, is this a simple setup, just tie them in to the existing UPS. I have a Minuteman online 2000VA, only 2 batteries and they are small. Can I set these Batts in the Equip Bldg in a "pan" and let them exist w/ active equip? I'm in Michigan and it gets fairly cold in Winter.
>-----Original Message----- >From: Travis Johnson [mailto:[EMAIL PROTECTED] >Sent: Wednesday, November 15, 2006 11:25 AM >To: 'WISPA General List' >Subject: Re: [WISPA] External battery on UPS > >We tried the $65 deep cycle marine batteries from Walmart. They worked >OK, but the best batteries we have found so far are the gel deep cycle >that are used in very large UPS systems. They weigh 110 pounds each and >are rated at 120 amp/hour and they do that for sure. > >We actually have a site out of power right now that has been running on >two of those batteries for 14+ hours so far and still shows another 8 >hours remaining. This is with three wireless radios, an HP 24 port >switch and a power rebooter all running off it. :) > >Travis >Microserv > >Mark Nash - Lists wrote: >> Ah-hah! I'll give this a try. Unfortunately the batteries I want to >> use are $200 each. ;) Got a recommendation on batteries that will >> last with constantly being charged by the UPS? >> >> Mark Nash >> Network Engineer >> UnwiredOnline.Net >> 350 Holly Street >> Junction City, OR 97448 >> http://www.uwol.net >> 541-998-5555 >> 541-998-5599 fax >> ----- Original Message ----- From: "Travis Johnson" <[EMAIL PROTECTED]> >> To: "WISPA General List" <wireless@wispa.org> >> Sent: Wednesday, November 15, 2006 6:13 AM >> Subject: Re: [WISPA] External battery on UPS >> >> >>> You can't use just 1 battery. The APC units want to see 24vdc, so you >>> need two batteries running in series. >>> >>> It works perfectly, as I have 20+ remote locations running off two >>> gel type batteries. Make sure you install some type of a fuse on the >>> positive side of the connection. >>> >>> Travis >>> Microserv >>> >>> Mark Nash - Lists wrote: >>>> I believe I remember some discussion on this list on connecting an >>>> external battery to an APC UPS. I'm in the middle of doing it right >>>> now and am having problems. The UPS just beep continuously with the >>>> 'bad battery' light on. I'm using a Lifeline deep cycle battery. >>>> Any ideas? >>>> >>>> Mark Nash >>>> Network Engineer >>>> UnwiredOnline.Net >>>> 350 Holly Street >>>> Junction City, OR 97448 >>>> http://www.uwol.net >>>> 541-998-5555 >>>> 541-998-5599 fax >>>> >>>> >>> -- >>> WISPA Wireless List: wireless@wispa.org >>> >>> Subscribe/Unsubscribe: >>> http://lists.wispa.org/mailman/listinfo/wireless >>> >>> Archives: http://lists.wispa.org/pipermail/wireless/ >>> >> >> >> >-- >WISPA Wireless List: wireless@wispa.org > >Subscribe/Unsubscribe: >http://lists.wispa.org/mailman/listinfo/wireless > >Archives: http://lists.wispa.org/pipermail/wireless/ > -- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/