The last time I had problems, it seemed to be okay when I skipped the long
cable. I haven't tried that this time around.
-----
Mike Hammett
Intelligent Computing Solutions
http://www.ics-il.com
----- Original Message -----
From: "Russ Kreigh" <[EMAIL PROTECTED]>
To: "'WISPA General List'" <wireless@wispa.org>
Sent: Wednesday, May 30, 2007 7:31 AM
Subject: RE: [WISPA] Ethernet problems
What if you plug directly (or as direct as you can) into the Mikrotik CPE
with your laptop??
-Russ
-----Original Message-----
From: [EMAIL PROTECTED] [mailto:[EMAIL PROTECTED] On
Behalf Of Mike Hammett
Sent: Tuesday, May 29, 2007 4:11 PM
To: WISPA General List
Subject: [WISPA] Ethernet problems
I installed a customer in October and started having Ethernet problems in
March. I have an approximately 200' Ethernet run from the top of a TV
tower, to the house, and through the basement. I installed a Belden?
outdoor Cat5E cable, a Mohawk outdoor gel cable, a rope for future cable
additions, and an RG6 quad shield TV cable in a conduit.
Numerous times I cut off slack on both ends of the original cable (the
Belden). All that fixed the problem was turning off auto negotiation and
setting it to 100 HDX. A few weeks later the problems returned, and I set
it to 10 HDX. Now, maybe 6 weeks later the problem is back. I switched
to
the Mohawk cable. I put on a different PoE injector and a different ECS
cable (PacWireless cable that provides an Ethernet jack on the outside of
the enclosure and has a 1' pigtail that plugs into the Mikrotik board.
Problem remains. The Mikrotik is getting power as it associates with my
tower and the two clients off an AP installed on the same board work just
fine. I tried different patch cables from the injectors to the
laptop\desktop.
I really don't want to pull 200' of cable only to have it not work again.
Does anyone have a good Ethernet tester I can borrow\rent? Not one that
just says if the pins make it (I had one of those and it said the cable
was
fine), but one that is a bit more advanced. From my understanding, these
are $800 - $5k units. Someone close to Northern Illinois would be best.
I'm out of ideas.
-----
Mike Hammett
Intelligent Computing Solutions
http://www.ics-il.com
--
WISPA Wireless List: wireless@wispa.org
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
--
WISPA Wireless List: wireless@wispa.org
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/
--
WISPA Wireless List: wireless@wispa.org
Subscribe/Unsubscribe:
http://lists.wispa.org/mailman/listinfo/wireless
Archives: http://lists.wispa.org/pipermail/wireless/