I had a link with XR5 at each end with 2ft dishes at each end that was 18.5 miles with no issue. I needed more throughput so went to Radwin radios with the same antennas.
Steve Barnes Manager PCS-WIN RC-WiFi Wireless Internet Service -----Original Message----- From: wireless-boun...@wispa.org [mailto:wireless-boun...@wispa.org] On Behalf Of Bret Clark Sent: Wednesday, April 28, 2010 3:02 PM To: WISPA General List Subject: Re: [WISPA] MT PtP What is the general or best case throughput on these radios in PTP configuration (speed/distance)? I googled for it, but saw a lot of very old post with conflicting info. I need to build a backup link for one of our primary's and if the MT's can do the job all the better! Kurt Fankhauser wrote: > Yes I have used the R5H and LOVE IT. Very nice card and a good price. I > think it performs better than the XR5. However some people say that the card > burns up easily but I run them all locked at 20db power output for all the > modulation rates. I do this for two reasons. First so that the signal level > stays consistent across all the rates, and Second, if they do have an issue > with burning up, I'm running them at 1db under their rated power output so > I'm not stressing the power amplifier built into the card. Also don't ever > power them up without an antenna attached I've heard that makes them burn up > as well. I have not had any such problems at all. > > Kurt Fankhauser > WAVELINC > P.O. Box 126 > Bucyrus, OH 44820 > 419-562-6405 > www.wavelinc.com > > > -----Original Message----- > From: wireless-boun...@wispa.org [mailto:wireless-boun...@wispa.org] On > Behalf Of Josh Luthman > Sent: Wednesday, April 28, 2010 10:30 AM > To: WISPA General List > Subject: Re: [WISPA] MT PtP > > Have you used the r5h? The r52n is very disappointing. > > On 4/28/10, Kurt Fankhauser <k...@wavelinc.com> wrote: > >> What 350mw card are you using? I wouldn't use anything less than XR5 or >> > R5H > >> because their receive sensitivity is so much better. Plus you will use >> > MMCX > >> connectors with these two cards which is going to save you a lot of >> headaches over u.fl. Also definitely turn on N-stream. I had a link that >> > was > >> bouncing around between 75-90% ccq and couldn't ever get it up higher than >> that. As soon as I turned on N-stream my ccq went to 100/100%. And >> modulation locks itself at 54/54 all day long. >> >> Kurt Fankhauser >> WAVELINC >> P.O. Box 126 >> Bucyrus, OH 44820 >> 419-562-6405 >> www.wavelinc.com >> >> >> >> -----Original Message----- >> From: wireless-boun...@wispa.org [mailto:wireless-boun...@wispa.org] On >> Behalf Of Akinlolu Ajayi-Obe >> Sent: Wednesday, April 28, 2010 2:23 AM >> To: wireless@wispa.org >> Subject: [WISPA] MT PtP >> >> I want to setup an MT point to point using two MT 411 boards, 350mw cards >> and a 23db rootena. Distance is 7km. Is there anything I need to tweak or >> watch out for? New to MT. I have setup a basic link and tested in the >> office. >> >> Thanks >> Akin >> Sent from my BlackBerryR smartphone >> >> >> >> > ---------------------------------------------------------------------------- > >> ---- >> WISPA Wants You! Join today! >> http://signup.wispa.org/ >> >> > ---------------------------------------------------------------------------- > >> ---- >> >> WISPA Wireless List: wireless@wispa.org >> >> Subscribe/Unsubscribe: >> http://lists.wispa.org/mailman/listinfo/wireless >> >> Archives: http://lists.wispa.org/pipermail/wireless/ >> >> >> >> >> > ---------------------------------------------------------------------------- > ---- > >> WISPA Wants You! Join today! >> http://signup.wispa.org/ >> >> > ---------------------------------------------------------------------------- > ---- > >> WISPA Wireless List: wireless@wispa.org >> >> Subscribe/Unsubscribe: >> http://lists.wispa.org/mailman/listinfo/wireless >> >> Archives: http://lists.wispa.org/pipermail/wireless/ >> >> > > > -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/ -------------------------------------------------------------------------------- WISPA Wants You! Join today! http://signup.wispa.org/ -------------------------------------------------------------------------------- WISPA Wireless List: wireless@wispa.org Subscribe/Unsubscribe: http://lists.wispa.org/mailman/listinfo/wireless Archives: http://lists.wispa.org/pipermail/wireless/